Search

Type: Posts; User: John F.

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. The TX goes to the Maptuner screen. If you still...

    The TX goes to the Maptuner screen.
    If you still can't get it to work work submit a support ticket at this address.

    https://plxdevices.freshdesk.com/support/tickets/new
  2. Read Step 2. As I stated in my last post. ...

    Read Step 2.
    As I stated in my last post.
    Disconnect the RX plug on the last PLX and put back in the jumper to see if your maptuner can read the O2 sensor data.
  3. Do you have the jumpers installed on all of the...

    Do you have the jumpers installed on all of the PLX's?

    1st try unplugging the RX on the last PLX by the battery and see if the Maptuner reads the single PLX O2 sensor.
    Also make sure the jumper...
  4. Replies
    2
    Views
    254

    Touch the red triangle at it will display the...

    Touch the red triangle at it will display the fault on the dash screen.
  5. Some people have had good results by cutting the...

    Some people have had good results by cutting the 1" rear lip off of the back of the ski.
    The upper deck lip grabs the water when on glass and causes the ski to rock side to side.
  6. Replies
    66
    Views
    3,809

    The fuel pressure stays steady until around...

    The fuel pressure stays steady until around 4200rpms and then progressively gets worse at higher rpm's.
    Nil's confirmed there is an issue but was not sure what was the exact cause.
  7. Replies
    66
    Views
    3,809

    Dan I never replaced the fuse. The ground could...

    Dan I never replaced the fuse.
    The ground could also be the issue as Shortbus stated as Riva sells their Seadoo 340 fp kit with a relay and lower gauge ground wire.
  8. Replies
    66
    Views
    3,809

    Yes. The afr was also fluctuating to the fuel psi.

    Yes. The afr was also fluctuating to the fuel psi.
  9. Replies
    66
    Views
    3,809

    On my Motec it records fuel pressure and I...

    On my Motec it records fuel pressure and I noticed that the fuel pressure started to bounce around 30psi (30-59psi) several times a second after 4200 rpms. I thought it was either the 340 fuel pump...
  10. I have used Yamalube as well but prefer the Lucus...

    I have used Yamalube as well but prefer the Lucus due to the less smoke formula and it is a TC-W3 semi synthetic formula.
    Stock you can use 87 octane. I have the MSD enhancer with advanced timing so...
  11. 1. I use this brand of oil that I purchase from...

    1. I use this brand of oil that I purchase from Academy Sports.
    https://lucasoil.com/products/2-cycle-oil/2-cycle-land-sea-oil-tc-w3

    2. The proper mix ratio is 50:1 with 91+ required.
    ...
  12. Replies
    5
    Views
    591

    With the Riva gen 3 I had to purchase the cooling...

    With the Riva gen 3 I had to purchase the cooling kit upgrade separately.
    I have both the Fizzle and the Riva gen 3 intercoolers on my skis and they both perform great.
    The advantages the Riva has...
  13. Replies
    4
    Views
    318

    253 Low oil pressure warning

    253 Low oil pressure warning
  14. Replies
    4
    Views
    468

    No. Only when changing a tune or when weather...

    No. Only when changing a tune or when weather cools down to check afr.
  15. Replies
    23
    Views
    1,790

    No, only a 19lb wheel.

    No, only a 19lb wheel.
  16. Replies
    23
    Views
    1,790

    19 SVHO stock wheel.

    19 SVHO stock wheel.
  17. Replies
    4
    Views
    468

    Only the map tuner as far as I know. With the...

    Only the map tuner as far as I know.
    With the data logging kit installed the map tuner displays engine sensor data except gps speed and your dash still works normally.
    This is just 1 page of data...
  18. Replies
    72
    Views
    5,141

    The Protec is +12mm over the stock steering...

    The Protec is +12mm over the stock steering nozzle length and 92mm diameter.
    By looking at the picture his might me slightly longer at about +15mm.
    The stock steering nozzle is also...
  19. Replies
    72
    Views
    5,141

    I just remembered that Dean's Team sell's a...

    I just remembered that Dean's Team sell's a modified extended stock steering nozzle for $120 that might also work.
  20. Replies
    72
    Views
    5,141

    I have 1 stainless fender washer under each bolt...

    I have 1 stainless fender washer under each bolt and still have about 2mm from plate to grate.

    TJBrad04 said his Riva plate is flush to his Riva grate without washers. Hopefully he can post a pic...
  21. Replies
    72
    Views
    5,141

    I believe $125. If there is enough interest...

    I believe $125.
    If there is enough interest maybe Jerry or Riva can place an order.
  22. Replies
    72
    Views
    5,141

    Update to a post I made earlier in this thread....

    Update to a post I made earlier in this thread.
    Today I ran the fuel down until the low fuel indicator stayed on to see if the Protec extended nozzle would still keep the ski from not bouncing.
    The...
  23. Replies
    23
    Views
    1,790

    I did a slower acceleration run trying to get...

    I did a slower acceleration run trying to get more accurate boost #'s.



    RPM
    MAP
    Boost
    1011mb
  24. Replies
    8
    Views
    448

    It would probably be easier to modify the stock...

    It would probably be easier to modify the stock steering nozzle.
    You would need to grind down the upper and lower tabs on the steering arm and drill and tap a new hole.
    This is a fairly common mod...
  25. Replies
    8
    Views
    448

    The only 2 companies that I know that have made...

    The only 2 companies that I know that have made the quick steering options are R&D Hydroforce nozzle and Pro Tec Racing.
    Ebay has some R&D hydroforce nozzles and Pro Tec has a limited # of nozzles...
Results 1 to 25 of 180
Page 1 of 8 1 2 3 4