Search

Search: Search took 1.00 seconds.

  1. Replies
    27
    Views
    3,494

    gesture ;)

    gesture ;)
  2. Replies
    6
    Views
    545

    Cable should be covered by warranty if out of...

    Cable should be covered by warranty if out of warranty once the cable has had water inside it will fail, might as well replace while you have it apart
  3. Replies
    6
    Views
    545

    since you have unhooked the nozzle and it still...

    since you have unhooked the nozzle and it still steers hard next un hook the cable where it connects to the handlebars, if the handlebars turn freely then the cable is the problem and needs...
  4. What have people towed for water toys with their Yamaha's?

    We do a lot of water sports with the kids during two weeks of camp every summer and I'm starting to worry how how our new Yamaha will do. We're going from a 2006 Sea Doo Wake 155 to a 2019 FX SVHO...
  5. Replies
    3
    Views
    323

    I have never used the right stuff, but I hear...

    I have never used the right stuff, but I hear it’s really good stuff
    I personally have used both 4200 and 5200 and I swear by them!
    I tossed the foam gasket that riva supplies and just used 4200...
  6. Replies
    33
    Views
    5,675

    About 200 riding hours and three summers. No...

    About 200 riding hours and three summers. No issues with the bond holding the bilge pump in place.

    Two bilge pumps on two 2017 GP1800 installed the same way. No issues.
  7. Replies
    14
    Views
    1,536

    I wouldn't worry about drilling the hull. I've...

    I wouldn't worry about drilling the hull. I've done both of my '18's in rear exit.
  8. Thread: Water in hull

    by K447
    Replies
    48
    Views
    6,216

    http://greenhulk.net/forums/showthread.php?t=27516...

    http://greenhulk.net/forums/showthread.php?t=275165&p=2983044&viewfull=1#post2983044

    http://greenhulk.net/forums/showthread.php?t=279334&p=3019717&viewfull=1#post3019717

    Link for the Antelco...
  9. Replies
    6
    Views
    717

    The short black hose about 8 inch long, 1.5...

    The short black hose about 8 inch long, 1.5 inches diameter, when looking in the rear of the ski under the seat. The impeller shaft goes through there.

    You're good to go other than that little...
  10. Replies
    6
    Views
    717

    Trick: Remove the spark plugs, then turn the...

    Trick: Remove the spark plugs, then turn the driveshaft/impeller backwards to unwind the rope. I've removed ropes undamaged before.
  11. Thread: Tow Tap 2019 VXR

    by K447
    Replies
    5
    Views
    901

    Tip: Check whether the flush hose is kinked down...

    Tip: Check whether the flush hose is kinked down where it joins the Y (X) connector.

    http://greenhulk.net/forums/showthread.php?t=275165&p=2985131&viewfull=1#post2985131
    ...
  12. Thread: Water in hull

    by K447
    Replies
    48
    Views
    6,216

    Water pressure from the garden hose (perhaps...

    Water pressure from the garden hose (perhaps surprisingly) does not seem to ‘open up’ the flush hose kink which occurs right at the X fitting (Y fitting on HO engines)

    Others have reported engine...
  13. Replies
    33
    Views
    5,675

    Whale Supersub SS1212 bilge pump installed in Yamaha GP1800 Waverunner

    I selected the SS1212 bilge pump for the low, narrow profile to fit into the rear compartment groove alongside the jet pump intake. Automatic electronic water sensor is located in the end opposite...
Results 1 to 13 of 13