Search

Anyone?

Hi

Thanks :).
Can I do this when the carbs are on or do I need to take them off?

Regards
Johan

Hi

Does anyone know how I set the carburetors on a XLT800? I think there must be some original settings?

Regards
Johan

how do i set the carburetors on an xlt800how do i set the carburetors...

Hi

I wounder if the engine from a xlt 800 -02 fits an xlt 1200-02? Do I need to change the enginebushings?

Regards
Johan

The splines looks have no damagehttp://greenhulk.net/forums/attachment.php?attachmentid=467101&stc=1
And the splines in the midshaft looks good as well, so it must be the ring...?

Regards
Johan

I found the nummer :)

Ok thanks, I will look after new ones at the shop.

There is no metal on the shaft, I think its the lights that may do some different lights/ look, I can take vetter picture tomorrow :).

I

The splints on both things looks good.http://greenhulk.net/forums/attachment.php?attachmentid=467067&stc=1

I

Thanks!
Do I need to change the hole pumphouse to get the plastic ring?

Do you meen this 2 o rings?
should it not be another seal where the green marking are?

You dont have anyone for sale?

https://www.ebay.com/p/2253423449


In that one? Do I need to change the hole part or could I just change the little shaft?
Thanks for all the answers :)

Im not 100 but I will check it in the comming weekend :)

One more thing, like I said it run great one week before and also when I started next time, but later on that day, 30 min after it started to do like that. But on the way back, in about 10mph, I...

https://www.ebay.com/itm/Yamaha-Jet-Pump-impeller-Housing-Wear-ring-XLT-XL-800-1200-1300-GP-GPR/223445589792?epid=25030359423&hash=item3406651f20:g:dbkAAOSwBRdchA9n

Do you think this one works? Or...

Its more than 0,024”, how do I know if its the impeller or the ring?

http://greenhulk.net/forums/attachment.php?attachmentid=466785&stc=1

Hi

Tnx.
No the problem is that when I give half/full acceleration it starts to ”slip”, like an bad car clutch. I was looking at the impeller and impeller house and I didnt see anything bad, the...

Hi

Does anyone know if it should be a seal where the shaft enter the hull? Its an xlt800 -02.

Regards
Johan



http://greenhulk.net/forums/attachment.php?attachmentid=466777&stc=1