Search

Page 1 of 7 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    1,977
    Views
    603,728

    Sticky: https://www.yamahapartshouse.com/oemparts/a/yam/50...

    https://www.yamahapartshouse.com/oemparts/a/yam/5003a7a7f870021f60a13f42/engine-hatch-1

    shows bolts in diagram. There’s one goes into the glove box and one on the chrome piece look for
  2. Replies
    8
    Views
    716

    My only comment, I k ow many here have had good...

    My only comment, I k ow many here have had good luck with them but they were not very consistent. I sent mine back 3 times, and they had never taken the rev limiter off. Was trying for years to...
  3. Pull the handle fully out so cable is extended...

    Pull the handle fully out so cable is extended then zip tie it. Thats how they come from factory. No packing
  4. Replies
    26
    Views
    3,234

    Jims Performance. Palm Harbor FL!! Top notch!!

    Jims Performance. Palm Harbor FL!! Top notch!!
  5. Replies
    4
    Views
    589

    Call Jims Performance get in touch with Victor...

    Call Jims Performance get in touch with Victor from Angelica racing. He fixes the impossible like brand new. Extremely reasonable too! He has a FB page too! Search Angelica tacing
  6. Replies
    3
    Views
    328

    its not a solenoid its a power valve motor. has...

    its not a solenoid its a power valve motor. has its own little circuit board. When it does that its one of 2 thing. the connector has corrosion and the pv motor constantly cycles or the pv motor...
  7. Replies
    8
    Views
    712

    It wouldnt matter because the check valve on the...

    It wouldnt matter because the check valve on the vent is the small size. Also your engine wont pull more fuel then the vent will allow in. Lastly on the aux tanks tbm etc you attach the vent line...
  8. Replies
    3
    Views
    485

    I personally am not a fan of the 32” bars. My...

    I personally am not a fan of the 32” bars. My riva and both sets of renthal 32’s i have cut down. I’ve takeen 1inch of both sides of all my sets for a narrower feel. to me 32 is to wide!
  9. Replies
    39
    Views
    6,310

    I bought the box with my triton trailer thats in...

    I bought the box with my triton trailer thats in the pic. Horrible, its tiny and doesnt fit anything. I upgraded to the bix box. They attached it with large self tappers and a 1/4 abs plastic...
  10. Replies
    24
    Views
    1,713

    the svho oil pan has a hole in the baffle so the...

    the svho oil pan has a hole in the baffle so the oil will all drain to one spot. when Jim did my SHO engine he drilled a hole in the baffel so all the oil comes out when siphoning from yhe dipstick....
  11. Replies
    4
    Views
    570

    Doesnt read below 5mph. I believe its in the...

    Doesnt read below 5mph. I believe its in the direction or used to be there
  12. Replies
    89
    Views
    13,159

    you have to take the pump off the shaft. Heat...

    you have to take the pump off the shaft. Heat the inside of the prop hub until its cherry then put in the vice. Should pop off. Heating the impeller fro the outside isnt enough. As said above...
  13. Replies
    23
    Views
    1,679

    looking at everyones pics....Guys you need to CA...

    looking at everyones pics....Guys you need to CA glue the perimeter of the face where the seem is. Your gonna get moisture in them over time. Been using them since 2001. Theres also a lable on the...
  14. Replies
    23
    Views
    1,679

    View Post

    Here’s jims mount
  15. Replies
    3
    Views
    327

    Make sure this bracket is off the exhaust and not...

    Make sure this bracket is off the exhaust and not on the cylinder either. then its a PIA bottom end in first turn and twist top. Maybe a couple of F%3ks inbetween
  16. Replies
    25
    Views
    2,650

    There’s no room on that trailer that why no one...

    There’s no room on that trailer that why no one has responded. Have one myself. Love it but can’t add anything unless your gonna start welding things on. no room on the tongue. Have the double as...
  17. Replies
    6
    Views
    944

    The grease fitting on the intermediate is not...

    The grease fitting on the intermediate is not actually for the bearing!! Its for maintianing th seal. If you pump more than 2 pumps in there per season you run the risk of blowing out the...
  18. Replies
    1
    Views
    284

    Starter bendix. Its a spring loaded gear that...

    Starter bendix. Its a spring loaded gear that engages the flywheel when the starter spins. they go bad. Cdi has nothing to do with the started engaging the actual flywheel
  19. Well Jerry don't burn me at the stake but I have...

    Well Jerry don't burn me at the stake but I have to disagree on this.
    For your first statement that all prop gauges are different I absolutly agree. The plastic ones for sure will all have...
  20. Replies
    35
    Views
    5,626

    I've got the 2-2 without brakes. Never had an...

    I've got the 2-2 without brakes. Never had an issue with it pushing. I tow and Fzr/xlt combo. So figure 1800 pounds with fuel. I have tomcheck sometime i dont even know its back there. ...
  21. Replies
    2
    Views
    913

    That needs to be on!!! Supports the weight of...

    That needs to be on!!! Supports the weight of the pump. Find one asap before you use the ski in the spring!! The older skies like the old gpr's and xlts did not have one but have a heavier...
  22. Did you by any chance ask jim?

    Did you by any chance ask jim?
  23. Replies
    24
    Views
    2,095

    mine has been in for 4 years no issue. heat sink...

    mine has been in for 4 years no issue. heat sink bung old style exhaust its an 09.
    i always am using the afr's when riding.
  24. Replies
    7
    Views
    1,326

    Your intake grate is cracked!!! Dont ride it get...

    Your intake grate is cracked!!! Dont ride it get a new one!! The outter left bar. Also six10 epoxy cover it up no one will see it do just skim coat it smooth.
  25. FS Worked for me thanks again!

    Worked for me thanks again!
Results 1 to 25 of 152
Page 1 of 7 1 2 3 4