Search

Type: Posts; User: johnt365

Search: Search took 0.03 seconds.

  1. Replies
    6
    Views
    661

    Hi Mark, What condition are the carb...

    Hi Mark,

    What condition are the carb diaphragms? Mine ran great one year and then sluggish the next. It turned out the diaphragms were distorted, likely from soaking in ethanol gas too long. $15...
  2. Replies
    4
    Views
    564

    Reporting back on this one. Took the carbs apart...

    Reporting back on this one. Took the carbs apart and the diaphragms were quite distorted. Replace them and she spins up to 6050. Just need to fine tune now.

    Thanks.
    john
  3. Replies
    1
    Views
    224

    Carb tuning with triple fuel pump?

    Hi all,

    I have a 95 SL750 and installed a triple output fuel pump years back. I did my best to tune it reading the plugs. In the manual, the settings for each high speed screw are different but...
  4. Replies
    4
    Views
    564

    Thanks for the quick tip. I disconnected the MFD...

    Thanks for the quick tip. I disconnected the MFD and the in water results were the same.

    I'm going to put new plugs in, do a proper plug chop and will post the results.

    Thank you,
    John
  5. Replies
    4
    Views
    564

    95 SL750 Lacks WOT power under load

    Hi all,

    I would really appreciate any advice you can offer to help me keep this piece of history on the water.

    My 95 SL750 ran great when I put it up for the winter last year. Now, it starts,...
  6. Replies
    4
    Views
    423

    Not damaged. Is there any reason I should not...

    Not damaged. Is there any reason I should not use them for fuel for primer ports? I hooked the lines to them and they squirt gas when I push the button.
  7. Replies
    4
    Views
    423

    your memory is a big help to me. Five minutes...

    your memory is a big help to me. Five minutes later and the primer lines are installed.

    Thank you very much.
  8. Replies
    4
    Views
    423

    Ocean Pro Vortex brass fitting question.

    I have an SL750 and use premix fuel. I wanted to install a primer kit and thought it would be easy with these brass fittings on these Ocean Pro Vortex flame arrestors I have. Below is a picture of...
  9. Brad, After reading your post I went and...

    Brad,
    After reading your post I went and disassembled the switch. Then, took apart the button assembly. Now, due to some recent austerity measures in our family I was motivated to take note that...
  10. How do I remove the kill switch on a 95 sl750

    Hi everybody, my SL-750 has been running great for several years. I am having a problem starting it that I believe is tied to the kill switch. (If I diddle with the button it will start) However,...
  11. Replies
    8
    Views
    898

    anybody slalom ski behind an SL 750?

    I have a 1995 sl 750 that runs great. It revs to just over 6000 rpms. I have never tried to ski behind it but I love to slalom. Before I embarrass myself at the lake, I was hoping someone could...
  12. these are good suggestions. It is almost like...

    these are good suggestions. It is almost like the wake is shaking the gas out of the carbs because it fires right back up.

    i suspect the kill switch and the fuel delivery. i will check the...
  13. Dies sometimes when i hit a wake going fast

    i have a 95 sl750 that seems to be running VERY good. However,sometimes it will die when i hit a big wake and usually when i hit it at full throttle. it starts right back up fine. so it happens...
  14. Replies
    3
    Views
    741

    the gears inside the unit get all rusted up too. ...

    the gears inside the unit get all rusted up too. i bought one on ebay and it was not tested before shipped. well it was rusted to pieces. the second one i asked the guy if he would open it up and...
  15. Replies
    36
    Views
    6,164

    Hang on now... I dont know Randy and never said...

    Hang on now... I dont know Randy and never said it was his fault. I don't think it was a rash comment at all. I fully agree that this forum is no place to air out problems with vendors. My point...
  16. Replies
    36
    Views
    6,164

    I used to do customer service for a major...

    I used to do customer service for a major electronics company. what happend to you sucks. I have one thing to add.

    DISPUTE THE CHARGE! hopefully you used a credit card and not a debit card. ...
  17. I did increase the fuel by about a full turn per...

    I did increase the fuel by about a full turn per carb appropriatly. I will admit I should have taken better notes.

    I will search the archives on the subject of plug chops. Its just a big...
  18. your experience with intake grate,ride plate and max rpm.

    Thanks again for all the great advice here. I have a few general questions. I have a 95 sl750 which the only mod so far is the Ocean Pro vortex flame arrestors.

    my max rpm is about 6050. Does...
  19. Replies
    3
    Views
    897

    broken throttle control on 95 sl750

    the plastic thumb control piece broke. I need some help getting a new throttle control. i appreciate any help you guys can offer, links, experience, pics whatever.

    1. do you know of a vendor for...
Results 1 to 19 of 19