Search

For the stage 2 plus 300 9200 VT11 tune it only states required parts as: Power filter, impeller, catch can, VT11s and the Riva Cam or stock at full retard. (This tune only shows on my maptuner...

I am interested if anyone has results from this tune as well. I am planning to run the stage 2 plus VT11 9200 tune. I will be using the Riva cam though instead of stock at full retard.

I agree there are many factors and no 2 skis will run identical. My experience with the 13/18 vs the stock has been they are very close to the same speeds. I am currently running the 13/18 still.

The solas 13/18 makes minimal difference over the stock. No reason to waste money on it. As MANY people have said go get a custom prop. Either new custom pitched solas or send the stock out to be...

Your getting basically maxed out for stage 2 at 81mph. Trying to go any faster I would do the valve train upgrade then go straight to stage 3. Adding the 13/18 on your stage 2 won’t do much and...

Stick to the stock prop. The 13/18 will not gain you much for what you will have to pay for it. The stock prop runs in the 8200-8300 range which what the target rpm is for stage 2. The closer you...

Who is the tune from? I don’t see a Riva 8300 tune for 2022. Did you mean stage 2 8500?

Each tune will tell you which supporting parts are needed to run the tune. The stock 8500 has no parts required. Do not expect to jump on the ski and run 8500 rpm. Without any mods you will most...

The stock impeller will work just as good as the solas 13/18. I have ran both on my stage 2 setup with my 21 tx. The 13/18 solas was not worth the cost vs sticking with stock. I would run the...

On my 21 tx the 13/18 solas was close to the stock setup. I gained maybe 100rpm. I sit at about 8200rpm. The stage 2 tune target range is 8300. I installed a 13/16 and was able to hit the...

21 TX
solas 13/18
riva intake
catch can
IMUK
Riva IC hoses
frogskinz over ski pylon hole and hole drilled under rear passenger seat
8550 rpm riva tune

I have a similar setup. It’s on a 21 tx. I’m using the riva intake and the solas 13/18. The solas seems very comparable to the stock prop my TX came with. Overall I see 77-78 dash on full tank at...

I am running the same setup as Water4fire. Only difference is i have the Riva intake. So far my results on a full tank range from 77-80mph dash speed depending on the day. I have seen as high as...

At 50hrs my slip was found at 6ft-lbs. I had it adjusted up to 12ft-lbs. This was on a 21 Rxt.

My friends 22 RXT is at the dealer with missing parts. It arrived at the end of April. It still needs the Gauges, RFDESS Post, ECM, DESS key, GPS, Throttle Sensor and Keypad Switch. He was told...

Finally got the ski back out for testing. Went back over the ski again and switched over to the standard 13/18 solas impeller. Was able to run 80-83mph depending on river current with RPM at 8300....

I will take a look at the pump seal when it all comes back apart again. The new riva seal was a much tighter fit than the stock one that came out.
Prior to installing the new parts the old seal was...

Latest update:

New Riva pump seal installed, wear ring and Solas 13/18 that was repitched by Impros to a 13/16.
Ski was bouncing the limiter at 8550 Rpms and only 70mph dash speed.

I have...

Took the ski out after drilling some holes for extra air and applied frogzskin. Was able to pull dash speed of 79mph 8200 rpm and low fuel of 81 mph 8300 rpm. Water was 65 degrees and air was 75...

Current plan is to take a razor and cut off the coating/paint material that is peeling. I am going to install a new solas 13/18 impeller pitched for 8300 target rpm by Impros. I am going to...

Here is a better picture of the damage.
http://greenhulk.net/forums/attachment.php?attachmentid=483878&stc=1

Looking at the wear ring and prop from under and behind the ski it appears with minimal wear. There is some coating coming off the ride plate or pump support not sure which piece that is....

I was able to get 80 on the dash at 8200-8300 but that was JP style with the seat off and of course not summer heat. After i give everything a look over i guess the next route will be a prop...

I will get the pump, prop and wear ring checked along with the SC slip. My guess is the prop/wear ring due to the water I ride in which always has some small debris in it.

What speed is everyone getting out of a stage 2 setup on their newer RXTs?

I am running the stage 2 8550 IMUK tune. I have the stock prop, RIVA intake and IMUK. Also the essential catch can.
My...