Search

Type: Posts; User: AlexZ

Search: Search took 0.00 seconds.

  1. Thanks for moving my post/question into the right...

    Thanks for moving my post/question into the right category ;)
  2. Replacing the anodes - how much should be remaining?

    Hi @ll!
    I did just the winterization of my RXT-X 2019 and was wondering when the anodes should be replaced.
    In the manual there is only 1 sentence about it: you should replace them when more than...
  3. Replies
    27
    Views
    1,393

    Does anyone know what the setting in Buds2 is...

    Does anyone know what the setting in Buds2 is duing with the ECU when set to SAR except from starting in sport mode?
  4. Replies
    4
    Views
    277

    I would use both compressed air as well as...

    I would use both compressed air as well as antifreeze.
    If there is some water trapped in the IC it could expand and damage the IC, so to be sure use the Antifreeze after the compressed air to mix...
  5. Sorry I was too fast, do you mean you want not...

    Sorry I was too fast, do you mean you want not the original zinc ones but others?
    I thought they were both for sea as well as fresh water...
  6. hi! no there a 3 anodes, at least for the 2019...

    hi!
    no there a 3 anodes, at least for the 2019 model, 1 in the intercooler, the one in your pic and one on the left side of the jetpump, you can see it from where you took the foto.
    the one for the...
  7. Replies
    5
    Views
    488

    What do you want to do? You can build one...

    What do you want to do?
    You can build one yourself you just need cables, connectors and the tape.
    In the shop manual there are the schematics which cable is connected to which device.

    Maybe it's...
  8. Replies
    12
    Views
    935

    I' not sure if the exhaust is like my 2019 RXTX...

    I' not sure if the exhaust is like my 2019 RXTX but the nut which holds the exhaust to the hull came lose.
    water started coming in slowly. Maybe you wan't to check that too.
    it's the big plastic...
  9. Replies
    17
    Views
    760

    Why don't you just wire it to the +12V which is...

    Why don't you just wire it to the +12V which is switched on when the ski wakes up?
    what do you mean by 3 wire? GND/VCC/ and source to messure?

    regards Alex
  10. Replies
    13
    Views
    1,458

    I used isopropanol 99% without any problems...

    I used isopropanol 99% without any problems except on the glove box panel.
    but be aware that it is listed as harmful to the cm tech hull.
    maybe it didn't harm anything because it was hot outside...
  11. Thread: HTTPS please

    by AlexZ
    Replies
    9
    Views
    12,338

    it's simply state of the art. No https lowers...

    it's simply state of the art. No https lowers search ranking scores and also most of the password managers as well as browser will complain about it.

    it shouldn't be complicated to add a...
  12. Replies
    7
    Views
    3,019

    Could you share some infos with me? I'm new to...

    Could you share some infos with me?
    I'm new to can "hacking" seadoos and want to try to find out as much as possible for my RXT-X300 2019.
    Will receice my can analyzer hopefully next week :)...
  13. Replies
    4
    Views
    573

    That is directly for the ECU connector not the...

    That is directly for the ECU connector not the diag? :-k
  14. Replies
    4
    Views
    573

    Sorry forgot about that. Specifically I'm...

    Sorry forgot about that.

    Specifically I'm asking for RXT-X 300 2019 and newer models.
  15. Replies
    4
    Views
    573

    Power Interface Cable for software updates

    hi!
    I'm not sure if this is the right forum but I give it a try.
    Can someone tell the schematic of the power interface cable for the diagnostic port?

    My guess is that it's just a connection...
  16. Thread: HTTPS please

    by AlexZ
    Replies
    9
    Views
    12,338

    Any plans to use https? The last post was a while...

    Any plans to use https? The last post was a while ago ;-)
    Would be great to have https :)
  17. Replies
    2
    Views
    501

    I use the XPS anti corrosive spray - I spray it...

    I use the XPS anti corrosive spray - I spray it on every (metal) part in the engine bay.
    Try to spray also the backside of the intercooler and on the exhaust...

    I'm on a freshwater river so I do...
  18. Thanks Scott, I have read that thread but it's...

    Thanks Scott,
    I have read that thread but it's not about the 2019 model and they tried to change the sensor from ECM input <-> CAN input.
    I'm not sure if the candoo would display the same LTS flags...
  19. Retrofit Lake Temperature Sensor (LTS from GTX-300) to RXT-X300

    Hello all!

    I've searched everywhere but I could find a thread/post about it.
    I wonder if it is possible to retrofit the lake temp sensor from the GTX 300 Limited to the RXT-X 300?

    The...
Results 1 to 19 of 22