Search

Search: Search took 1.00 seconds.

  1. Replies
    8
    Views
    774

    He was making up for the 8 years he was a member...

    He was making up for the 8 years he was a member and never posted (almost). All those trouble free hours no time to go on the internet :D
  2. Check the ignition box and see what is in there....

    Check the ignition box and see what is in there. What are the compression numbers for you on a fresh top end?
  3. Replies
    93
    Views
    3,839

    ...

    ...
  4. Replies
    26
    Views
    1,196

    Did you by any chance hook up a garden hose when...

    Did you by any chance hook up a garden hose when you attempted to start it? The procedure for the jetskis is to have the motor running before the water is turned on or there is a chance the hose can...
  5. Replies
    1
    Views
    207

    Even if there were any parts in the motor that...

    Even if there were any parts in the motor that were reusable it would be hard to justify the cost especially since you would probably need a new supercharger. Then add all the labor on top it adds up...
  6. Replies
    93
    Views
    3,839

    I think the Ultra cylinder is 7mm taller than the...

    I think the Ultra cylinder is 7mm taller than the 15f. Why did you need to interchange ? Just get the custom pistons for the 15f spend your time and money on other stuff like the pump.
  7. The rotors are teflon coated which tends to flake...

    The rotors are teflon coated which tends to flake off when subjected to salt water and poor post ride care. The rotors are not available separately but there was/is a guy who was able to refinish...
  8. Have you pulled the fuel pickup out and inspected...

    Have you pulled the fuel pickup out and inspected it? I had one with a cracked tube, they are old and brittle.
  9. Replies
    4
    Views
    510

    Yea.. If you cant find the carbs you may be in...

    Yea.. If you cant find the carbs you may be in over your head.
  10. Thread: 15F engine

    by TMiller
    Replies
    2
    Views
    350

    WTB I just sold one complete a couple months ago...

    I just sold one complete a couple months ago $1200 shipped. Let you know if another lands anytime soon.
  11. Replies
    12
    Views
    611

    Exhaust leak will bring rpm down. Check the blue...

    Exhaust leak will bring rpm down. Check the blue coupler and try running without the seat on. If you havent already CHECK THE PUMP for peace of mind.
  12. If your cases are damaged on the core motor I...

    If your cases are damaged on the core motor I think SBT may charge you extra for that.
  13. Well wasnt sure if youd checked that, just didnt...

    Well wasnt sure if youd checked that, just didnt want to overlook something simple. If the plates arent being held open then like has been said sounds like a leak. I would check over whatever you had...
  14. [QUOTE=beekermartin;3029249]I haven't changed any...

    [QUOTE=beekermartin;3029249]I haven't changed any cables. This was not a problem before I replaced the burnt piston.


    You removed the motor..... Is the throttle cable set correctly? There...
  15. That rear cylinder is hurt. I saw that you water...

    That rear cylinder is hurt. I saw that you water tested before changing the oil lines and going through the carbs and seemed to run ok. Did you run it hard at that point or were you going easy on it...
  16. I had an stxr sitting for a few years kind of...

    I had an stxr sitting for a few years kind of forgot about it. I recently started going through it and found a few gallons of fuel in it which melted all the rubber parts off the fuel level sender.
  17. Replies
    2
    Views
    707

    Part the 250 motor and try to find a 300. 300 is...

    Part the 250 motor and try to find a 300. 300 is a better motor and blower.
  18. Replies
    7
    Views
    1,466

    I dont see why it would matter in the end the oil...

    I dont see why it would matter in the end the oil is still going to the same place. No rebuild kits for the stock fuel pump you can buy a complete pump new for like $130
  19. Replies
    14
    Views
    1,856

    I didn't mean that the vibration would go away if...

    I didn't mean that the vibration would go away if you unplug wire. I meant it would confirm that the cylinder is not working if you don't notice a change with it unplugged. Wouldn't hurt to check...
  20. May be easier to send a rod into the spark plug...

    May be easier to send a rod into the spark plug hole turn the motor by hand and measure the stroke. Wouldn't be exact but should be enough difference to tell the two apart.
  21. Thread: Piston pics

    by TMiller
    Replies
    5
    Views
    941

    Piston pics

    http://www.greenhulk.net/forums/attachment.php?attachmentid=378779&stc=1http://www.greenhulk.net/forums/attachment.php?attachmentid=378780&stc=1
  22. Thread: 2003 STXR

    by TMiller
    Replies
    48
    Views
    4,278

    Did you check that the motor is parallel to the...

    Did you check that the motor is parallel to the driveshaft? If you move the front of the motor up or down it changes that angle. You could shim the rear mounts also - either/or. Side to side angle...
  23. Replies
    8
    Views
    1,125

    Well he has 100% positive feedback and has been a...

    Well he has 100% positive feedback and has been a member since 8/21......... 2014.


    We should all start sending questions like crazy and see how they like that.
  24. Replies
    24
    Views
    2,902

    FS No waterbox. Down to one cylinder left and...

    No waterbox. Down to one cylinder left and complete bottom end.
  25. How about $15,000 turn key with a 4 year...

    How about $15,000 turn key with a 4 year warranty. :-k
Results 1 to 25 of 25