Search

Type: Posts; User: fx160

Page 1 of 8 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    4
    Views
    110

    FS - Parts I think you can buy the Kawasaki exhaust outlet ...

    I think you can buy the Kawasaki exhaust outlet
    And it will work with the rest of the kit
  2. Replies
    177
    Views
    21,324

    4-Stroke View Post

    Jeez thatís some bad luck
    Or maybe it was good luck that it didnít break while engine was running
  3. Replies
    104
    Views
    5,757

    Sounds like water must be getting on sensor and...

    Sounds like water must be getting on sensor and destroying it
    If tune is ok
    Just keep an eye on your plugs
    And make sure they donít look lean
  4. Thread: Motec

    by fx160
    Replies
    10
    Views
    500

    View Post

    Iím pretty sure you can setup a second tune
    And switch to it when needed
    It will still be a problem though when you have a mix of both
  5. Replies
    20
    Views
    1,441

    Sounds like a tune would be best for what you are...

    Sounds like a tune would be best for what you are looking for
  6. Replies
    104
    Views
    5,757

    Yes start with that Could also be a crack in...

    Yes start with that
    Could also be a crack in the connector at bottom of sensor
    I would start by replacing the vacuum hose
  7. Replies
    104
    Views
    5,757

    View Post

    If itís within .2 of old one
    It must be another fault
    Try looking at Map sensor
    As that will change the fuel mix if it reads the boost wrong
  8. Was a lot discussion on the for sale post about...

    Was a lot discussion on the for sale post about them not being a true 160 pump
  9. View Post

    Didnít we find out itís not really 160 all the way through
    But the same as the earlier pumps
    Starting at 155 and finishing as 160
  10. Replies
    104
    Views
    5,757

    I had something similar going on with my ski ...

    I had something similar going on with my ski
    And struggling to find a cause
    Pretty sure I have now found the issue
    Only because it got worse
    I found the vacuum hose to the map sensor had a...
  11. Replies
    4
    Views
    374

    The Ho pumps had a 2 inch extension I believe...

    The Ho pumps had a 2 inch extension
    I believe the rest was the same
    So shaft should be longer as well
  12. Replies
    11
    Views
    528

    View Post

    Itís done for hole shot
  13. Replies
    18
    Views
    1,076

    View Post

    Iím sure he could get a tune that drops the rev limit
    It would achieve what he is trying to do
  14. Replies
    12
    Views
    403

    I think kero dissolves salt So maybe spray them...

    I think kero dissolves salt
    So maybe spray them with kero
    Or even try salt away
    Otherwise maybe cut at each bolt
    Leaving a bit of bolt so you have something to grip when trying to bolt out...
  15. Replies
    2
    Views
    309

    The cheeper the stainless the more magnetic The...

    The cheeper the stainless the more magnetic
    The more magnetic the easier it will rust
  16. Replies
    18
    Views
    2,796

    Super jets are built in Japan

    Super jets are built in Japan
  17. Replies
    5
    Views
    168

    Worst case scenario bolts could have snapped on...

    Worst case scenario bolts could have snapped on starter ring destroying the charging system ( yes Iíve had it happen )
    If itís the earth block
    Thatís located on the back of the motor right hand...
  18. Replies
    12
    Views
    403

    It should just come straight off Maybe remove...

    It should just come straight off
    Maybe remove the pump just to make sure there is no parts jamming on it
  19. Replies
    1
    Views
    230

    Just recently did mine on my FZS 2010 Old mats...

    Just recently did mine on my FZS 2010
    Old mats came off really easy ( I got lucky )
    457220

    Iím really happy with the end result

    Still have to do my sons 2014 FZS
    But we know his will be a...
  20. Replies
    1
    Views
    219

    I got lucky on my 2010 FZS The old mats came...

    I got lucky on my 2010 FZS
    The old mats came off with most of the glue
    So clean up was easy 457219
    And I think the new mats look great
  21. Most likely to be a crack in cylinder head ...

    Most likely to be a crack in cylinder head
    Known fault
    Canít be seen by eye either
  22. Thread: gprxp

    by fx160
    Replies
    1,431
    Views
    125,874

    gprxp

    Good work
    So what did you have to change to make the seadoo pump fit ?
    Was it just the cutout that I can see in pics
  23. Thread: 2012 fx problem

    by fx160
    Replies
    8
    Views
    415

    Check for water past coils Or could be a fuel...

    Check for water past coils
    Or could be a fuel pump failing
  24. Replies
    1
    Views
    165

    Yes you can The Ho throttle body is larger on...

    Yes you can
    The Ho throttle body is larger on the inside
    But same external dimensions
    Will most likely increase the idle though
    I lent mine to my son who has a 2014 svho with a tune
    when...
  25. Replies
    35
    Views
    2,831

    View Post

    Iíve had one go within an hour
    And it was replaced
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4