Search

Type: Posts; User: casey67

Page 1 of 8 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    6
    Views
    182

    Welcome to GreenHulk. The crankshaft is...

    Welcome to GreenHulk.

    The crankshaft is pressed together. A complete crankshaft rebuild is needed, it looks like bearings from the crankshaft found their way to the top of the piston. At that...
  2. IIRC, the "block off kit" was the block off plate...

    IIRC, the "block off kit" was the block off plate and 3 rubber caps for the carb oil fittings.
    The block off plate just bolts to the front of the engine.
    The 1200's use a white plastic oil pump...
  3. Replies
    27
    Views
    1,549

    The 96-97 SLTX had 38mm w/accel 98-99 SLTX had...

    The 96-97 SLTX had 38mm w/accel
    98-99 SLTX had 40mm w/accel same as SLX/SLXH. All 1200 carb models had 40mm w/accel (other then 1999 X45/SLTX-B) jets were different nearly every year/model.


    ...
  4. Genesis i CAN NOT run premix. On CARB models...

    Genesis i CAN NOT run premix.


    On CARB models the oil pump is lubricated by the oil it pumps.
    Premix will not lube the pump.
    Lines need to be capped off to prevent air entering carbs.
  5. Replies
    27
    Views
    1,549

    Yeah, I realized I was really focused on the...

    Yeah, I realized I was really focused on the chamfering for the 1050.

    Like most models, the different years 1050/700 used different cylinders. 96-97 used the added port that later models/parts...
  6. Replies
    27
    Views
    1,549

    Chamfering is simply removing any sharp edge at...

    Chamfering is simply removing any sharp edge at openings so that the rings will not get snagged.
    Look at the angles at the openings of the cylinders BEFORE it gets bored.
    Anybody that bores...
  7. Replies
    10
    Views
    235

    It's not that bad. At $700 it's still worth it,...

    It's not that bad. At $700 it's still worth it, not as great as the $600 deal but those don't happen that often.
    During the summer,running Genesis sold for an average $2000.

    Id pull the heads...
  8. Replies
    11
    Views
    290

    We have all been new to Polaris at some point....

    We have all been new to Polaris at some point. Yeah, there have been alot of great people contribute to the forums, everyone has tried hard to keep info as accurate as possible. Sometimes there is a...
  9. Replies
    11
    Views
    290

    The "P" is for projected. It sits further into...

    The "P" is for projected. It sits further into the cylinder then plugs without P.

    Again Polaris strangely listed BPR9ES for only the 2001 1200.I tried both in my 1200 with no difference at all....
  10. For got to mention, the 448 was specific to the...

    For got to mention, the 448 was specific to the update kit. But really any 2 cylinder CDI timing curve will be really close. In like 2003 Polaris used a "high start" CDI that made timing a little...
  11. There does seem to be a supply shortage at this...

    There does seem to be a supply shortage at this time. I would have to guess because to the world wide pandemic.

    When new Genuine PVL CDI were available, they did cost $350-$400. Used were around...
  12. Replies
    11
    Views
    290

    Not sure why the Polaris manual has 8's listed,...

    Not sure why the Polaris manual has 8's listed, all other 1200's even the 99 X45 use 9's.
    As xlint mentioned the 8's are hotter=too hot damages pistons.

    I would use the BR9ES , it is safer and...
  13. The burnt wires appear to be from the handle bar...

    The burnt wires appear to be from the handle bar controls harness.
    Did you say you took the switch apart ?
  14. Timing ? What IS the spec for pop-off ?...

    Timing ?

    What IS the spec for pop-off ?
    Needle arm heaight set ?
    Needle arm diaphragms correctly installed/facing correct direction ?
  15. Replies
    15
    Views
    290

    Correct, SLX has a taller box then your Virage. ...

    Correct, SLX has a taller box then your Virage.

    Not sure why Polaris added the second box for 2 years ? of the SLTX. Only advantage I can think of is a shorter MFD harness ( SLTX has MFD in the...
  16. Replies
    15
    Views
    290

    So you have a S L T X ? Maroon 3 seater ?

    So you have a S L T X ? Maroon 3 seater ?
  17. Replies
    15
    Views
    290

    SLX 1 ebox SLTX 2 eboxes ...

    SLX 1 ebox
    SLTX 2 eboxes

    https://parts.polarisind.com/Browse/Browse.asp
  18. Replies
    15
    Views
    290

    Plastic electrical box for 1999 SLX.

    Plastic electrical box for 1999 SLX.
  19. Replies
    15
    Views
    290

    On top of the battery, battery and box are held...

    On top of the battery, battery and box are held down with 2 rubber straps.
  20. Replies
    15
    Views
    261

    Red/pur is the fused battery power wire. It...

    Red/pur is the fused battery power wire. It distributes power to the entire ski.

    Orange is the switched power wire. The LR gets a signal that the engine is running (yellow wire).An AC volts signal...
  21. Replies
    6
    Views
    216

    WTB Yeah, and give your phone number to ANY company,...

    Yeah, and give your phone number to ANY company, sit back and watch all the spam calls/ scammers/politicians come in !
  22. Replies
    6
    Views
    216

    WTB NON-SCAMMER ,PM sent....lol.. Dear friend please...

    NON-SCAMMER ,PM sent....lol.. Dear friend please consider.
  23. Replies
    16
    Views
    646

    Exactly. You never really know the entire...

    Exactly. You never really know the entire procedure unless you do it yourself or have a really good technician that refuses to do things wrong/halfway.

    I agree, starting with truely clean oil on a...
  24. Replies
    16
    Views
    257

    Yes, If you plan on having a second jetski on...

    Yes, If you plan on having a second jetski on that trailer, those tires will hold the weight.

    If you are only going to have the Genesis alone on that trailer the standard 4.80-12 will be fine.
  25. Replies
    16
    Views
    646

    Turbo's spin at really high rpm's, like double...

    Turbo's spin at really high rpm's, like double triple engine rpm. It's pretty rough on oil.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4