Search

Type: Posts; User: wolf513

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    8
    Views
    1,200

    http://img.tapatalk.com/d/14/07/27/a7e5abyv.jpg

    http://img.tapatalk.com/d/14/07/27/a7e5abyv.jpg
  2. Replies
    8
    Views
    1,200

    It looks like the bearings had failed. Before...

    It looks like the bearings had failed. Before taking it apart I could only count 4. The rest and the plastic spacers had slide further inside the housing....
  3. Replies
    52
    Views
    35,264

    Sticky: I just elected to remove it for now. Maybe I'll...

    I just elected to remove it for now. Maybe I'll trim it shorter later on.
  4. Replies
    8
    Views
    1,200

    Thanks for the help. Yup I had a touch down. ...

    Thanks for the help. Yup I had a touch down. $#% there goes my riding this summer. I missed most of last year, while I waited for my exhaust valves to be replaced.

    Just over 61 hours. I...
  5. Replies
    8
    Views
    1,200

    Splitting open the Supercharger

    I think I had supercharger touchdown this weekend. :(

    I heard a faint clinging sound while the engine was idling. When I removed the supercharger when I got home there was gray dust inside.
    ...
  6. Replies
    3
    Views
    1,476

    Do you have yours setup as a static psi or in the...

    Do you have yours setup as a static psi or in the 1:1 rising rate mode?
  7. Replies
    3
    Views
    1,476

    04 RXP base psi for Riva rrfpr

    I just installed the Fizzle F1000, Graco strainer, and a RIVA Rising Rate Fuel Pressure Regulator in my 2004 RXP.

    I currently don't have AFR gauge. What would be a good base psi to set for the...
  8. Replies
    52
    Views
    35,264

    Sticky: 335125335126 The stock rear air duct hits on...

    335125335126

    The stock rear air duct hits on the IC pipe from the supercharger.
  9. Replies
    52
    Views
    35,264

    Sticky: I am in the process of installing this in my 04...

    I am in the process of installing this in my 04 RXP. I am having a problem getting the rear air intake duct to fit back in place.

    Do I need to remove or shorten the rear air intake or is my...
  10. Replies
    132
    Views
    84,397

    Sticky: Anybody have a good link for a how-to on the...

    Anybody have a good link for a how-to on the exhaust valve replacement steps?

    Also are there any special tools required?

    I've done all the other mods on my ski, but I want to make sure of...
  11. Replies
    9
    Views
    1,309

    Thanks for the advice. I'll just save myself the...

    Thanks for the advice. I'll just save myself the hassle and get the real parts.
  12. Replies
    9
    Views
    1,309

    Bosch 42# injectors

    Is there a difference between the 42# Bosch Injectors sold here
    http://www.4-tecperformance.com/index.php?main_page=product_info&cPath=18_52&products_id=363

    And these ...
  13. Replies
    132
    Views
    84,397

    Sticky: I have an 04 RXP that sat out last season due to...

    I have an 04 RXP that sat out last season due to the birth of my kids, and I am looking to replace my exhaust valves to prevent future damage.

    What type of valves would you guys recommend as a...
  14. Replies
    18
    Views
    2,076

    I've got a similar setup, and I am putting up...

    I've got a similar setup, and I am putting up about the same RPMs. The highest I've seen is the occasional 7950. Usually I am around 7800. looking at this thread I think I am going to try to...
  15. FS last chance on these items before they go out...

    last chance on these items before they go out with the trash on friday
  16. FS 04 RXP Resonator and stock air intake (only pay shippping)

    I am cleaning out my garage and I am looking to get rid of the following items.

    Just pay for the shipping and they are yours!

    04 RXP Stock Resonator (~25hrs of use)

    04 RXP Stock Air Intake...
  17. I usually just wedge my arm down by the front...

    I usually just wedge my arm down by the front left side of the engine near the oil filler cap.
    It takes some patience, because I can only get my arm in and out at just the right angle. Then once my...
  18. Does that make for a big difference in handling...

    Does that make for a big difference in handling ability?

    Seems like if you're gonna shell out the big bucks, might as well collect all the electronic bells and whistles.

    Kinda like choosing...
  19. Nice technology in the iS models. I've been...

    Nice technology in the iS models.

    I've been using my reverse lever for years to help slow down fast. Usually when I am doing 65 towards the no-wake zone bouys, and need to slow down fast. 8-[...
  20. Replies
    1,179
    Views
    132,935

    Tick...Tock...Tick....Tock only a few more...

    Tick...Tock...Tick....Tock

    only a few more hours left:smt119
  21. Replies
    5
    Views
    739

    what do those pissers go to?

    what do those pissers go to?
  22. Replies
    17
    Views
    1,923

    If it is still under warranty I would choose mods...

    If it is still under warranty I would choose mods that wouldn't void the warranty.
    Then do the bigger mods when the warranty is up.
  23. Replies
    22
    Views
    5,208

    +1 This is exactly how I did it. I just flip...

    +1

    This is exactly how I did it. I just flip the wheel up on the front of the trailer so the trailer nose sits on the ground and the RXP pump is up in the air. This makes it alot easier to get...
  24. I just installed mine last week and I agree...

    I just installed mine last week and I agree completely. The handling is more predictable and seems a little more nimble. It is even a lot easier to maneuver in reverse.

    Great all around mod!
  25. Replies
    22
    Views
    5,208

    I ride in fresh water - so bye bye nose cone. ...

    I ride in fresh water - so bye bye nose cone. The more I read about it the more headaches it seems to cause.

    Thanks:)
Results 1 to 25 of 93
Page 1 of 4 1 2 3 4