Search

Type: Posts; User: Gixxxerboy

Page 1 of 5 1 2 3 4

Search: Search took 0.00 seconds.

  1. Replies
    11
    Views
    675

    I asked Fizzle this the other day and he told me...

    I asked Fizzle this the other day and he told me you do not have to run the upgraded cooling mod. Bolt up an go
  2. Replies
    19
    Views
    1,346

    I reached my hand thru the grate and tried...

    I reached my hand thru the grate and tried twisting the collar or cone but it seemed very tight. Not sure if that tiny bit that is not flush with the impeller would cause cavitation being that the...
  3. Replies
    19
    Views
    1,346

    After reading this, I crawled underneath to get a...

    After reading this, I crawled underneath to get a look at my nose cone because I have tons of cavitation from a dead. My nose cone does not look completely seated and flush up against the impeller....
  4. Replies
    25
    Views
    874

    Is anyone out there using a lithium battery? I...

    Is anyone out there using a lithium battery? I have one in my Yz450. It sat all winter and it starts right up after long intervals of sitting. I know a ski requires way more to turn over than just...
  5. Place the flame of the torch into the hole on the...

    Place the flame of the torch into the hole on the backside. You will have to leave it on there for 30-45 seconds to get the loctite to release. immediately after removing the torch, use a P3...
  6. I removed these 2 bolts yesterday. I had to...

    I removed these 2 bolts yesterday. I had to remove them to install speaker bracket. THE ONLY WAY THESE ARE COMING OUT IS BY HEAT. Use a small torch on the backside of the bolts. Then ONLY a P3...
  7. Sticky: I just installed these on my Gp 1800 2 weeks ago....

    I just installed these on my Gp 1800 2 weeks ago. I can tell you that they are a very tight fit and the holes are drilled precisely. I used the larger Fx bosses on top with longer bolts. While I had...
  8. http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=442832&stc=1 I was going to use but not sure. Might just get the inserts from Jerry
  9. Sticky: What is the best silicone or sealant to use when...

    What is the best silicone or sealant to use when putting the pump back on
  10. Replies
    21
    Views
    6,364

    Beats Pill Plus puts out good sound.

    Beats Pill Plus puts out good sound.
  11. Thread: GP

    by Gixxxerboy
    Replies
    2
    Views
    361

    Yes but a tune woke it up

    Yes but a tune woke it up
  12. Thread: GP

    by Gixxxerboy
    Replies
    2
    Views
    361

    GP

    Got a chance to ride some a river with some pretty tight turns for the first time on my Gp. All I can say was WOW!!! This thing was on a rail and shot out of corners like crazy, all while riding two...
  13. Replies
    42
    Views
    3,996

    clear marine silicone from walmart. i put in on...

    clear marine silicone from walmart. i put in on the backing plate only. put a thin layer around the entire edge of backing plate and around the hole onthe backing plate
  14. Replies
    42
    Views
    3,996

    yea not sure why riva and worx are on different...

    yea not sure why riva and worx are on different pages there! I followed the instrucrion about using the marine silicone with worx and I used blue loctite on the bolts. That was 3 weeks ago and been...
  15. Totally unacceptable!!!!!

    Totally unacceptable!!!!!
  16. Some no good SOB's!!! I will have to find...

    Some no good SOB's!!! I will have to find somebody willing to tackle the reinforcement.
  17. I just got off the phone with Yamaha Corporate. I...

    I just got off the phone with Yamaha Corporate. I explained that I have a 2018 Gp 1800 with 14 hours and have not yet experienced what others have with the defective portion of the hull. The...
  18. Christian was the same representative that I...

    Christian was the same representative that I spoke with and he told me the same thing.lol
  19. I just got off the phone with them. They said...

    I just got off the phone with them. They said that they dont have any reported cases of a problem
  20. I just got off the phone with Yamaha Corporate. I...

    I just got off the phone with Yamaha Corporate. I explained that I have a 2018 Gp 1800 with 14 hours and have not yet experienced what others have with the defective portion of the hull. The...
  21. I have 14 hours on mine and have been keeping a...

    I have 14 hours on mine and have been keeping a close eye on the grate. I dont see any stress mark or cracks as of yet. I'm sure you can get a better look by removing the grate. I work a lot as most...
  22. Replies
    15
    Views
    1,442

    You will definitely enjoy the 1800! Once you...

    You will definitely enjoy the 1800! Once you flash it, it becomes a whole new animal !! you can sit back and laugh at the dipshits that say "look at the results on the watercraft journal"LOL All it...
  23. Replies
    6
    Views
    436

    I came off of an 07 rxp with a good bit of mods...

    I came off of an 07 rxp with a good bit of mods (73mph). I got a gp a couple months ago. So glad I made the move!!!! Flashed the gp and running 79mph bone stock. This thing pulls to the moon. My rxp...
  24. Best thing I could have done!! You are absolutely...

    Best thing I could have done!! You are absolutely right for only a grand you pick up gobbbs of power and roughly 9mph on the hill. Such a small invest ment compared to what it cost a few years ago...
  25. Replies
    42
    Views
    3,996

    Lol. Trying to keep this as a sleeper! No...

    Lol. Trying to keep this as a sleeper! No exhaust, waterbox etc
Results 1 to 25 of 105
Page 1 of 5 1 2 3 4