Search

Search: Search took 1.00 seconds.

  1. Replies
    5
    Views
    507

    I have always felt there is way too much concern...

    I have always felt there is way too much concern about pop off pressure. Go by the mikuni specs for needle and seat size and spring color/type, and its good. And always use OEM parts! Mikuni knows...
  2. I always remove the entire exhaust when pulling...

    I always remove the entire exhaust when pulling carbs. You will need to to get to the oil pump anyway. There are a total of 10 bolts holding the carb rack on. 2 thru each carb, and 4 hexhead with...
  3. The yellowish crap ruining everything is corn...

    The yellowish crap ruining everything is corn residue in the ethanol fuel. Thank your government for that. Pull and inspect needles first. I probably go through 100 or more carbs every season and...
  4. The higher port timed cylinders will not require...

    The higher port timed cylinders will not require a 20+ jump on the main with the factory single pipe. Thanks for your advice but I'll adjust what I have.
  5. Replies
    19
    Views
    2,526

    I always just rebuild the carbs using the mikuni...

    I always just rebuild the carbs using the mikuni kits and everyone who has been around any ski I owned is always impressed with how well they start and run. Then again, I dont do a bunch of engine...
  6. Replies
    9
    Views
    942

    Those couplers are crap. They allow too much...

    Those couplers are crap. They allow too much free play in the shafts. The oem ones are almost better.
  7. Replies
    10
    Views
    1,072

    SuperTech 2 stroke TCW3 and I burn A LOT of it!

    SuperTech 2 stroke TCW3 and I burn A LOT of it!
  8. I use, and recommend the WSM kits. Gaskets are...

    I use, and recommend the WSM kits. Gaskets are OEM quality, pistons and everything else are OEM quality in my opinion, never had a problem with any of the ones I have used. Run far far away from...
  9. I think it's a good idea to keep the oil...

    I think it's a good idea to keep the oil injection.
    I went premix on my XLT1200 last year. This year I put the pump back on because I was tired of the loading up at idle and the excessive smoke.
    If...
  10. Replies
    41
    Views
    3,319

    I've personally had better luck with lead acid...

    I've personally had better luck with lead acid batteries over AGM and Gel-cell.
  11. Replies
    15
    Views
    2,084

    The USA models were jetted to meet USA emission...

    The USA models were jetted to meet USA emission standards. Hence the cat, and leaner jetting. The European standards were much more lax. While it is lean jetting, in stock settings it does not...
  12. Replies
    9
    Views
    1,467

    Your ground wire or connection is open if you are...

    Your ground wire or connection is open if you are getting 12 volts on the starter ground stud. It's getting 12 v through the starter windings.
  13. Replies
    78
    Views
    12,309

    Sounds like you may have a little external water...

    Sounds like you may have a little external water leak. You'll want to fix that.
    You could still take it out on the water for a bit if you want, but keep an eye on that water leak.
Results 1 to 13 of 13