Search

Type: Posts; User: K447

Search: Search took 0.11 seconds.

  1. Replies
    73
    Views
    29,622

    Setting and adjusting trailer bunk spacing to match your hull

    I typically use either the inside to inside edge bunk spacing or the outside edge to outside edge measurement when setting up bunks. Center to center measurements are not very useful for bunks.

    It...
  2. Replies
    73
    Views
    29,622

    That is certainly the general consensus, almost...

    That is certainly the general consensus, almost everyone prefers the controlled ride and reliability of the torsion axle.

    The lack of suspension rattle and minimal noise even over bumps on the...
  3. Replies
    73
    Views
    29,622

    On the double Triton the frame is reinforced...

    On the double Triton the frame is reinforced along where the torsion axle attaches.

    Does the single PWC Trition with torsion axle from the factory have a reinforcement or frame configuration that...
  4. Replies
    73
    Views
    29,622

    How to clean corroded copper wires using salt + vinegar, baking soda solutions

    Reproduced here for future reference.



    I will mention that stranded wires will tend to wick the solutions up into the wire core inside the insulation. So when soaking in the baking soda...
  5. Replies
    73
    Views
    29,622

    Old school trailers ran a single power wire to...

    Not Triton specific, but here's a site with potentially helpful information:

    http://www.accessconnect.com/trailer_wiring_diagram.htm[/QUOTE]

    I had seen that but the triton is nothing like it. I...
  6. Replies
    73
    Views
    29,622

    The rust from the bolt has expanded to lock the...

    The rust from the bolt has expanded to lock the bolt into the aluminum sleeve.

    You can soak the assembly in a strong alum solution. I recently posted about using alum.

    The alum will dissolve...
  7. Replies
    73
    Views
    29,622

    I presume you are installing new bunk boards with...

    I presume you are installing new bunk boards with new bunk carpet. I use a woodworking router with a roundover bit and round off all six edges on each bunk board prior to installing the carpet....
  8. Replies
    73
    Views
    29,622

    Those look like aluminum brackets. If aluminum...

    Those look like aluminum brackets. If aluminum then there are chemical products that will remove the iron/steel rust and leave the aluminum alone.

    I am sure there are some commercial products that...
  9. Replies
    73
    Views
    29,622

    It might be easier to buy replacement bunk...

    It might be easier to buy replacement bunk brackets. Check a few of the online trailer parts sources. You might find the cost to be reasonable.

    I use the EvapoRust product to clean rust from parts...
  10. Replies
    73
    Views
    29,622

    Another member added round bumpers (Stoltz bow...

    Another member added round bumpers (Stoltz bow stop rollers) to the rear corner steps to prevent hull damage if the hull happened to get too close.
    ...
  11. Replies
    73
    Views
    29,622

    My understanding is that all models and years of...

    That's my primary concern, plus not having maintenance free hubs.

    Not sure if their torsion axle models have those hubs or not...[/QUOTE]My understanding is that all models and years of Triton...
Results 1 to 11 of 11