Search

Type: Posts; User: 1tommygunner1927

Page 1 of 8 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    11
    Views
    385

    Is cooling closed or open loop? And the...

    Is cooling closed or open loop?

    And the dealer "left my spark plugs and coils sitting under inches of water in the footwell outside in the rain, & oil on the seat and obviously covering the...
  2. Replies
    11
    Views
    385

    The PTO seal has 2 O-rings inside the bearing and...

    The PTO seal has 2 O-rings inside the bearing and the PTO coupler also has a seal. Were all in place after driveshaft replacement?
  3. Replies
    96,146
    Views
    10,147,815

    Hmmmm, well, maybe younger a younger wife...... ...

    Hmmmm, well, maybe younger a younger wife......

    https://nypost.com/wp-content/uploads/sites/2/2021/08/clintons-in-the-hamptons-676.jpg?quality=90&strip=all&w=1024
    ...
  4. Replies
    96,146
    Views
    10,147,815

    https://upload.wikimedia.org/wikipedia/commons/thu...

    https://upload.wikimedia.org/wikipedia/commons/thumb/6/6a/Elizabeth_Warren%2C_official_portrait%2C_114th_Congress.jpg/256px-Elizabeth_Warren%2C_official_portrait%2C_114th_Congress.jpg...........I...
  5. Replies
    9
    Views
    481

    The shorter runners will produce less torque in...

    The shorter runners will produce less torque in the lower rpm range (built in launch control). The only negative with aluminum intakes manifolds (I have the Riva/Wilson intake), once the engine is...
  6. This is good advice! Do the Stage 2 mods, then...

    This is good advice! Do the Stage 2 mods, then water test it to observe maximum rpm, then adjust pitch if needed. Impeller is always last.
  7. Replies
    8
    Views
    316

    The baffled air/oil cans are much more expensive...

    The baffled air/oil cans are much more expensive than a "catch can".
  8. Your ski will run on 89 non ethanol gasoline. If...

    Your ski will run on 89 non ethanol gasoline. If knock is detected the ECU will will reduce performance by reducing ignition timing. Your ski is designed for and SeaDoo recommends 91 octane or higher.
  9. Replies
    3
    Views
    158

    2018 & newer SVHO, this is a MUST READ! Remove...

    2018 & newer SVHO, this is a MUST READ! Remove flame arrestor ribbon disc

    http://greenhulk.net/forums/showthread.php?t=295336
  10. Replies
    24
    Views
    2,817

    The use of an extending rod with a small magnet...

    The use of an extending rod with a small magnet will remove keeper from the valve.
  11. Replies
    8
    Views
    316

    There are "catch cans" and air/oil separator...

    There are "catch cans" and air/oil separator cans:



    Catch Can......https://rivaracing.com/images/M144968269.jpg

    ...
  12. Replies
    96,146
    Views
    10,147,815

    I wonder who will visit the Lincoln bedroom...

    I wonder who will visit the Lincoln bedroom during this time!
  13. Replies
    24
    Views
    2,817

    If anything is dropped into the engine other than...

    If anything is dropped into the engine other than oil......I'm pulling the engine.
  14. LOL.....those are the correct plugs for the 300,...

    LOL.....those are the correct plugs for the 300, not the 4339's. Too many people pinch pennies and usually it comes back to bite you!
  15. Item 16: ...

    Item 16:

    https://partsfinder.onlinemicrofiche.com/4tec/showmodel.asp?type=13&make=seadoopwc&a=613
  16. In your first post..... ...

    In your first post.....

    https://rivaracing.com/i-24082628-ngk-kr9c-g-90893-standard-nickel-spark-plug-sea-doo-300hpengines.html
    ($10.95 per plug for the 300)

    VS
    ...
  17. Replies
    24
    Views
    2,817

    I feel your pain.....which is why I always block...

    I feel your pain.....which is why I always block the head oil drains with shop paper towels, same for the cam chain bay when removing/installing cam bolts, TOPS washer, or those 2- 6mm head bolts.
  18. Replies
    15
    Views
    2,425

    They are Nylok nuts.....replace them. One time...

    They are Nylok nuts.....replace them. One time use.....maybe twice!
  19. Replies
    24
    Views
    1,017

    Plug in relevant info: ...

    Plug in relevant info:
    https://wahiduddin.net/calc/calc_hp_dp.htm
  20. Replies
    15
    Views
    1,317

    [QUOTE=slydogge;3150376] Go for it.....be the...

    Go for it.....be the Beta Tester! Let us know about their after sales support.
  21. I haven't seen the latest style bellows but its...

    I haven't seen the latest style bellows but its my understanding it has 2 round metal bands to stiffen the bellows. Not sure the O-rings are needed.
  22. Its been awhile since I've used the stock...

    Its been awhile since I've used the stock driveline however, if I recall correctly the O-rings are 2.5" or so in diameter x .5" thick. Best to take a used bellows with you to the hardware store for...
  23. Replies
    96,146
    Views
    10,147,815

    The Brookings Institute.......and Hillary Clinton...

    The Brookings Institute.......and Hillary Clinton (and others). Its about to hit the fan!
  24. Add 2 - large O rings to the bellows. This will...

    Add 2 - large O rings to the bellows. This will increase the pressure applied to the carbon seal to hat and will help reduce cavitation. When assembling the drive line, simply roll the O-rings off...
  25. [QUOTE=1tommygunner1927;3149935] Moving...

    Moving sponsons forward, or making them shorter
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4