Search

Type: Posts; User: SplishSplash

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    22
    Views
    1,156

    There is no comparrison of the handling of the...

    There is no comparrison of the handling of the Ultra 150 and the 310. The 150 is a light, quick, nimble machine that a blast to ride but it can bite you hard at speed if you catch a cross wave. (its...
  2. Replies
    50
    Views
    1,831

    OK, for the beep codes, its saying its the wrong...

    OK, for the beep codes, its saying its the wrong key, not programmed for the machine.
    One log Beeeeeeep, (wrong key) 3 beep beep beep, key on des post , its a reminder there is a key on the post. ...
  3. Replies
    12
    Views
    499

    Going to have to think about the fuel pump...

    Going to have to think about the fuel pump statement. I think the fuel pump runs the same speed all the time. Does not increase with RPM or load. The fuel pressure regulator controls the Fuel flow....
  4. Could be an exhaust leak inside the hull, That...

    Could be an exhaust leak inside the hull, That will cause a rough idle and no power as you did touch the exhaust.
    Could be a cracked intake manifold or some damage from the ribon delete, or vaccum...
  5. Replies
    11
    Views
    652

    I guess the original (2004) system must have been...

    I guess the original (2004) system must have been better. I run Xcharger, custom tune, 4 inch intake and to this day, not one drop has ever shown up in my intake, SC or even the hose from the tops...
  6. Also every wave would disconnect the phone. Do...

    Also every wave would disconnect the phone. Do you use it for music or something because a fullcharge should last all day anyway and why would you need a charger.
  7. Replies
    7
    Views
    571

    Your missing the point, those that sank or almost...

    Your missing the point, those that sank or almost sank due to the carbon ring, did not sink because there is anything wrong with the design. They sank because things were not installed correctly....
  8. Replies
    1
    Views
    194

    How many hours did you hav on them? Are the...

    How many hours did you hav on them?
    Are the keepers still in place?
    What other mods?
    Is the piston cleaner other than the damage than the others?
    Pics?
    Breaking half the head off, means it hit...
  9. Replies
    7
    Views
    571

    SeaDoo enginners didn't "Lie" The carbon seal...

    SeaDoo enginners didn't "Lie" The carbon seal design is good for hundreds of hours if the engine and driveline are properly aligned and motor mounts are not broken.
    No mater if the seal were made...
  10. Replies
    15
    Views
    1,204

    I would just go to your local watercraft retailer...

    I would just go to your local watercraft retailer and see what they have on display. It will give you a much better idea of whats out there and how they would suit you.
    Just buying blindly off the...
  11. See post #13 That must have been a coooold...

    See post #13
    That must have been a coooold swim back to the trailer! Your lucky you did not get hypothermeia! Glad your ok!
  12. Replies
    5
    Views
    235

    Start with the usual suspects. Supercharger let...

    Start with the usual suspects.
    Supercharger let go
    Flywheel bolts let go
    Timing chain let go
  13. Replies
    2
    Views
    246

    Check the basics, battery fully charged and in...

    Check the basics, battery fully charged and in good health, then connections, then fuses and clean dess post
  14. Poll: Don't know why this would be a survey? Year and...

    Don't know why this would be a survey?
    Year and model would help.
    Intake? as in engine air intake?

    If your concerned, just remove the spark plugs, crank it over and see if water shoots out. If...
  15. Yep, for sure, and the OP better find out why it...

    Yep, for sure, and the OP better find out why it sank or else it will do it again!
  16. Replies
    6
    Views
    541

    As far as I know, neither come with the cap...

    As far as I know, neither come with the cap o-rings. Non I have bought in the last 5 years be it old or new style had any in the box.
  17. Replies
    9
    Views
    496

    Those flywheel bolts? Hardware store? Can you...

    Those flywheel bolts? Hardware store? Can you tell what grade they are?
  18. You say it turns over, does it sound different...

    You say it turns over, does it sound different than before?
    Was it the cluster working for the 15 min it was running?

    If it sounds totally different when trying to start, you may have lost the...
  19. Replies
    7
    Views
    456

    I doubt you would even notice the difference if...

    I doubt you would even notice the difference if you did somehow manage to get 80 lbs out. Don't waste your time on it. Just add more power and that will net far bigger gains over removing 80 lbs.
  20. Did you try contacting Hydroturf? They made my...

    Did you try contacting Hydroturf? They made my custom seat with the Seadoo Yellow in it.
  21. Replies
    3
    Views
    138

    I see your delima, $380 for a new OEM one is more...

    I see your delima, $380 for a new OEM one is more than the ski is worth.
    Hopefully someone on here has one in thier parts bucket and can help you out. I looked in my old 650 parts and sorry I...
  22. Do all 2018 driveshafts rust like that in fresh...

    Do all 2018 driveshafts rust like that in fresh water use? Just asking as my 15 year old one has no rust like that. Are they not stainless anymore?
  23. I think your price is a bit inflated. I had a...

    I think your price is a bit inflated. I had a local print shop do vinyl boat # and name for $50 canadian including cost of vinyl and it included a custom graphic in the boat name.

    Looks good...
  24. Valve failure reason? I sould suspect neglect!

    Valve failure reason? I sould suspect neglect!
  25. Replies
    12
    Views
    549

    Sadly if it is the flywheel bolts, it takes out...

    Sadly if it is the flywheel bolts, it takes out the magneto windings too most of the time.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4