Search

Type: Posts; User: 99searay

Search: Search took 0.00 seconds.

  1. 2005 SX230 HO Intermediate Shaft/Seal Assembly

    I have a 2005 SX230/HO and the port engine intermediate shaft seal failed over the weekend and needless to say water was pouring in. I am hoping someone on this forum has replaced this part before...
  2. Replies
    4
    Views
    651

    trasti...I appreciate the reply and will...

    trasti...I appreciate the reply and will certainly try that.


    Anyone have other suggestions?
  3. Replies
    4
    Views
    651

    2003 XLT 1200 Issue

    I have a basically stock 2003 XLT 1200. Only mods are waveater clips, premix, and D-plate/temp sensor chip. I am having an intermittent problem and hoping I can get some suggestions from the...
  4. Replies
    5
    Views
    495

    Ok got the pump out...heat gun did the trick....

    Ok got the pump out...heat gun did the trick. Crank spins freely so the wear ring was the issue. Guess I needed just a little more patience today.
  5. Replies
    5
    Views
    495

    Thanks for the replies...This is with the head...

    Thanks for the replies...This is with the head off new cylinder in place. No signs of any debris in the crank. After further troubleshooting I think my wear ring my be swollen and the impeller is...
  6. Replies
    5
    Views
    495

    2003 XLT 1200 Crank Help

    Ok I picked up an 2003 XLT 1200 for a steal. Bad compression in center cylinder. I am in the process of replacing the cylinder and piston with OEM parts. Question is should the crank and pistons spin...
  7. WTB - Parts PM sent

    PM sent
  8. Replies
    3
    Views
    462

    WTB I have one in good condition $15 Shipped ...

    I have one in good condition $15 Shipped

    http://www.greenhulk.net/forums/images/imported/2011/11/106.jpg

    Parting 2000 GPR lots of parts available

    http://www.wix.com/wcgriffin67/gpr1200
  9. WTB If you are still looking Im have 3 wave eater...

    If you are still looking Im have 3 wave eater clips. Parting out my ski so I set up the following temporary site.

    http://www.wix.com/wcgriffin67/gpr1200
  10. Sticky: Great Info!!!

    Great Info!!!
  11. Replies
    18
    Views
    1,918

    5mm South East, VA

    5mm South East, VA
  12. Replies
    6
    Views
    3,472

    I like it.

    I like it.
  13. Replies
    3
    Views
    499

    Thanks millertyme26...this is the exact advice I...

    Thanks millertyme26...this is the exact advice I was hoping to receive. The center cylinder is definitely different from the other two which appear to have a sleeve. I was thinking the other two had...
  14. Replies
    3
    Views
    499

    Help Diagnose Root Cause

    Ok I have a 2000 GPR 1200 which I picked up at the beginning of the summer. Well I ran into issue the past week and have no compression in my my middle cylinder (other 2 are good). I spend a lot of...
Results 1 to 14 of 14