Search

Type: Posts; User: K447

Page 1 of 8 1 2 3 4

Search: Search took 0.30 seconds.

  1. Replies
    10
    Views
    346

    Not installing a bilge pump is never a better...

    Not installing a bilge pump is never a better idea than installing a bilge pump.

    There will always be some situations where the incoming water flow overwhelms the installed bilge pump capacity.
    ...
  2. Replies
    10
    Views
    346

    Use a high capacity bilge pump with automatic...

    Use a high capacity bilge pump with automatic electronic water sensing as your 'alarm'. Bilge pump connected to battery power, so not affected by engine running or not running.

    Locate the bilge...
  3. Replies
    6
    Views
    139

    I removed the entire OEM factory Yamaha speed...

    I removed the entire OEM factory Yamaha speed sensor paddle wheel assembly.

    http://greenhulk.net/forums/showthread.php?t=265092&p=2887887&viewfull=1#post2887887
    ...
  4. Replies
    6
    Views
    139

    I installed CANDooPro speedo modules when the...

    I installed CANDooPro speedo modules when the watercraft had less than 20 running hours and were only a few months old from brand new purchase, if that. Accurate speedometer + no more paddle wheel to...
  5. Thread: Water in hull

    by K447
    Replies
    33
    Views
    3,344

    http://greenhulk.net/forums/showthread.php?t=27516...

    http://greenhulk.net/forums/showthread.php?t=275165&p=2983044&viewfull=1#post2983044

    http://greenhulk.net/forums/showthread.php?t=279334&p=3019717&viewfull=1#post3019717

    Link for the Antelco...
  6. Replies
    11
    Views
    482

    Why are you asking this question? Is something...

    Why are you asking this question?

    Is something broken with the supercharger on your engine?
  7. Replies
    6
    Views
    139

    Are any of the paddles on the speedo wheel...

    Are any of the paddles on the speedo wheel damaged at all?
    IIRC there is a tiny magnet in the tip of a couple of the paddles. If it falls out then the speed reading will be incorrect.

    Also check...
  8. Replies
    3
    Views
    145

    Santa Rosa Sound (Navarre and west of Navarre)...

    Santa Rosa Sound (Navarre and west of Navarre) the water temp was 63-66F yesterday.
  9. Thread: SDBA

    by K447
    Replies
    2
    Views
    81

    What is that an acronym for?

    What is that an acronym for?
  10. Thread: Rxt performance

    by K447
    Replies
    2
    Views
    188

    So just install a set of new spark plugs? ...

    So just install a set of new spark plugs?




    https://www.4-tecperformance.com/images/DCPR8E.jpg
    Sea Doo NGK DCPR8E Spark Plug for all 4-Tec Skis
    NGK Spark Plug for all Sea Doo 4-Tec Engines....
  11. Replies
    17
    Views
    534

    2007 Seadoo - what model?

    2007 Seadoo - what model?
  12. How far does the sensor bottom extend below the...

    How far does the sensor bottom extend below the ride plate bottom surface?

    Was there any effect at all on the GP1800 ride, handling, stability at speed?

    Does it lose depth readings above a...
  13. Thread: Sea doo coolant

    by K447
    Replies
    5
    Views
    119

    Using the correct Seadoo coolant would be the...

    Using the correct Seadoo coolant would be the safe approach.

    I do not know which aftermarket coolants are fully compatible with the Seadoo stuff.
  14. This might be helpful. ...

    This might be helpful.

    http://greenhulk.net/forums/showthread.php?t=280816&p=3031032&viewfull=1#post3031032

    http://greenhulk.net/forums/attachment.php?attachmentid=447191&d=1553737096
  15. Thread: Sea doo coolant

    by K447
    Replies
    5
    Views
    119

    Correction: Propylene glycol, not polyethylene ...

    Correction: Propylene glycol, not polyethylene

    Seadoo uses a specific chemistry coolant. Do not mix any other chemistry coolant with the OEM product.

    The color of the coolant is not an...
  16. Thread: Sea doo coolant

    by K447
    Replies
    5
    Views
    119

    Propylene glycol type, correct?

    Propylene glycol type, correct?
  17. Replies
    9
    Views
    84

    Inspect carefully all the thin black wires inside...

    Inspect carefully all the thin black wires inside the electrical box. Often when the external thin black wire is toasted one or more of the internal thin black wires can also be cooked.

    Also...
  18. Replies
    9
    Views
    84

    10.5 to 11.0 volts while cranking is right around...

    10.5 to 11.0 volts while cranking is right around or below the minimum voltage the CDI needs. There may be some other problem(s) also affecting spark, but a marginal/weak battery can confound...
  19. Replies
    9
    Views
    84

    Did you remove and clean the engine end of the...

    Did you remove and clean the engine end of the heavy battery ground cable?

    Also clean the bolt and bolt hole threads and any other grounding wire ends at that bolt.
  20. Replies
    9
    Views
    84

    View Post

    Welcome.

    What voltage ‘minimum’ are you seeing while the engine is cranking? 10.5 would be quite marginal.
    Is this being measured right at the battery posts?

    If you press and hold the Bilge...
  21. Replies
    4
    Views
    96

    The Hall Effect sensors are not wire coils, they...

    The Hall Effect sensors are not wire coils, they are electronic sensors that detect the passing of a tiny magnet embedded in the flywheel timing ring.

    With Hall Effect sensors the exact ohms...
  22. Replies
    18
    Views
    1,605

    2018? Companies create prototypes and...

    2018?

    Companies create prototypes and experimental internal things often. Whether a thing becomes a manufactured product that goes into (low volume?) production and made available for general sale...
  23. Replies
    18
    Views
    1,605

    View Post

    In what form is this ‘confirmation’?
  24. Replies
    4
    Views
    96

    Welcome. Which coils are you testing?

    Welcome.

    Which coils are you testing?
  25. Replies
    21
    Views
    447

    PWC riding, especially on water that is not...

    PWC riding, especially on water that is not smooth, can require some strength and stamina. Riding while seated in rough water can certainly be hard on the back.

    The hull does not have suspension...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4