Search
Type: Posts; User: Spooling
Search: Search took 0.01 seconds.
-
11-14-2019, 02:25 AM
- Replies
- 15
- Views
- 1,337
--------------------------------- There can only...
---------------------------------
There can only be one reason for this. You guys from the "Land Down Under" are upside down !!! :)
Even the fresh water in your toilet bowls does not rotate work... -
11-12-2019, 03:11 AM
- Replies
- 15
- Views
- 1,337
------------------------------ Here's a couple...
------------------------------
Here's a couple of older Threads for your reading pleasure:
http://greenhulk.net/forums/showthread.php?t=223442
... -
11-08-2019, 08:01 AM
- Replies
- 15
- Views
- 1,337
--------------------------------- Everybody's...
---------------------------------
Everybody's been through this. I inspected mine at 25 hours and it was fine - I then inspected it at 50 hours and it was stuck in the water box. If I would have... -
11-08-2019, 07:50 AM
Thread: 2012 ultra 300x
by Spooling- Replies
- 3
- Views
- 197
Maintenance
--------------------------
There are a few things that should be checked before requesting additional advice - as all of these things have been covered over-and-over in redundancy on this Kawasaki... -
11-03-2019, 08:16 AM
Thread: New Kawa 325 model?
by Spooling- Replies
- 4
- Views
- 559
---------------------------- Yes sir - maybe...
----------------------------
Yes sir - maybe 2021 or 2022 - yet my un-educated assumption will be based on (this here + 10 years) = 2023:
https://www.youtube.com/watch?v=8n63DS2GdKg
Kawasaki's... -
11-03-2019, 08:12 AM
- Replies
- 9
- Views
- 367
One can make an assumption based on the...
One can make an assumption based on the Geographic Location (FL_Rider) of the OP using the process of elimination as follows:
--------------------
1. https://pwcengine.com/contact-us/ ... -
11-03-2019, 07:54 AM
- Replies
- 21
- Views
- 919
------------------------------------------...
------------------------------------------
Couldn't have been a more convenient place to have discovered that.
Certainly much better being in your garage vs. 25 miles away from your Launch Ramp.... -
09-30-2019, 11:20 AM
Thread: 2020 Lineup ?
by Spooling- Replies
- 53
- Views
- 3,358
A "Teaser" of what's to come from Kawasaki in 1...
A "Teaser" of what's to come from Kawasaki in 1 weeks time - from the Aussies?
https://www.brisbanekawasaki.com.au/
http://greenhulk.net/forums/attachment.php?attachmentid=454318&stc=1 -
09-27-2019, 07:35 AM
- Replies
- 14
- Views
- 695
--------------------------------- A block of...
---------------------------------
A block of wood works wonders. I think the pump - with the hoses supplied - is really designed for boat applications - where the oil extractor pump is generally... -
09-27-2019, 06:45 AM
- Replies
- 14
- Views
- 695
------------------------------------------ Yep -...
------------------------------------------
Yep - that's the best one in most everyone's opinion - except that guy wants to retire on oil extractor sales at 82 dollars + 105 dollars to ship = almost... -
09-23-2019, 04:41 PM
- Replies
- 3
- Views
- 290
Some Late Model Ultra-300's and Early Model 310's...
Some Late Model Ultra-300's and Early Model 310's had something funky in the ECM Code.
Reference:
http://greenhulk.net/forums/showthread.php?t=229347&p=2522104&viewfull=1#post2522104
When... -
09-19-2019, 05:48 AM
Thread: 2020 Lineup ?
by Spooling- Replies
- 53
- Views
- 3,358
----------------------------------- We're ALL...
-----------------------------------
We're ALL ready to see - you have something to share with us?
Reference:
https://www.kawasaki.com/
Looks like Monday October 07, 2019
... -
07-12-2019, 06:06 AM
- Replies
- 992
- Views
- 35,266
--------------------------- As I do in every one...
---------------------------
As I do in every one of my Posts here on this Bulletin Board - I ALWAYS send the seeker of information "Good Luck" - and you are indeed no exception.
Everyone... -
07-11-2019, 02:58 PM
- Replies
- 992
- Views
- 35,266
---------------------------------- While...
----------------------------------
While kartracer as well as yourself make valid points - I will say that in his "Pre-Purchase 2002 STX-r" thread that some good advice was offered by some... -
06-30-2019, 04:14 PM
Thread: 2008 Ultra LX 1500cc won't go over 40mph
by Spooling- Replies
- 6
- Views
- 312
1. Take it for a ride with both seats off - even...
1. Take it for a ride with both seats off - even the rear section held on by 4-10 mm cone head nuts removed would also help - and report back if you gained your MPH back. Exhaust hose going to the...
-
06-24-2019, 01:40 PM
- Replies
- 23
- Views
- 1,732
My take is that it's this one here: ...
My take is that it's this one here:
http://greenhulk.net/forums/attachment.php?attachmentid=450049&stc=1
I had a similar problem when my Ultra-300x was new - reference:
... -
06-24-2019, 01:26 PM
- Replies
- 992
- Views
- 35,266
Did you find out WHAT caused that piston to...
Did you find out WHAT caused that piston to "hole" - if not the Probability is HIGH that this might just happen again - in rather short order.
Kawasaki is "sweetening" the deals NOW for summer... -
06-24-2019, 01:19 PM
Thread: 2017 stx 15f. Loose steering
by Spooling- Replies
- 7
- Views
- 366
Here's a Post I created - yet this was for the...
Here's a Post I created - yet this was for the Kawasaki Ultra Platform:
http://greenhulk.net/forums/showthread.php?t=241819
Hope this is helpful for you.
Good Luck !!! -
06-24-2019, 01:16 PM
- Replies
- 23
- Views
- 1,732
Congrats on your new skis. I think the post...
Congrats on your new skis.
I think the post you are looking for is here:
http://greenhulk.net/forums/showthread.php?t=278829&p=3016185&viewfull=1#post3016185
Tighten your hose clamps - you... -
06-03-2019, 03:02 PM
- Replies
- 992
- Views
- 35,266
If you want to "maximize" your upcoming "summer...
If you want to "maximize" your upcoming "summer fun" - my recommendation is to put a new piston in that thing, clean up the cylinders and crankcase as best you can and go visit your Local Kawasaki...
-
05-29-2019, 04:17 PM
Thread: Ultra 300X Problem....
by Spooling- Replies
- 6
- Views
- 553
---------------------- Classic Symptoms: ...
----------------------
Classic Symptoms:
http://greenhulk.net/forums/showthread.php?t=221364
Good Luck !!! -
05-15-2019, 09:19 AM
- Replies
- 992
- Views
- 35,266
You can tie the oil pump cable WFO with a zip-tie...
You can tie the oil pump cable WFO with a zip-tie before your start-up. This will allow the lines to "bleed" faster.
Also, in order for you to pre-fill each line with 2-Stroke Injection Oil -... -
05-09-2019, 05:34 AM
Thread: 2015 310R surging
by Spooling- Replies
- 11
- Views
- 1,130
-------------------------------------- Hey...
--------------------------------------
Hey Stuart:
What's the Boost Gauge doing during this time - bouncing up and down like an Aussie Kangaroo?
Maybe it's time to conduct the following:
... -
05-08-2019, 06:50 AM
Thread: 300x Preventative Maint. - LOST TOOLS?!
by Spooling- Replies
- 10
- Views
- 722
----------------------------- A Shop Light is...
-----------------------------
A Shop Light is PFB - I kinda find it hard to believe it has mysteriously disappeared - a flashlight maybe but a shop light ???
Anyways, I would certainly give it... -
05-05-2019, 04:09 PM
Thread: imported 310lx
by Spooling- Replies
- 20
- Views
- 843
Lincoln, Nebraska
https://www.youtube.com/watch?v=Vi4ejb1Y2BQ
Results 1 to 25 of 200
I have an rxt 260 m.y. 2010. I have machined the 260 oem supercharger to...
215-260hp upgrades to 300...