Search

Type: Posts; User: NitroShark

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    4
    Views
    245

    What happens when you try to restart it?

    What happens when you try to restart it?
  2. Replies
    4
    Views
    253

    I would look at the spark plug readings first. If...

    I would look at the spark plug readings first. If you don't know how/what to look for then just change them. That's my best guess.
  3. Replies
    12
    Views
    1,481

    The ECU and TCP has nothing to do with your...

    The ECU and TCP has nothing to do with your problem. That's why I ask you to test with the wastegate actuator disconnected. You should of got instant Full boost. You did not, so now the turbo or...
  4. Replies
    12
    Views
    1,481

    There is your problem, little or no boost. ...

    There is your problem, little or no boost. Possibly -bad turbo, or leaky intake or exhaust. Revving the ski up under no load on the trailer is meaningless and could do harm to your ski.

    What...
  5. Replies
    12
    Views
    1,481

    When you disconnect the line going to the waste...

    When you disconnect the line going to the waste gate actuator does the ski Over-boost? It should easily spike to 12 PSI and try to shut down. Do this in the water and be warned it should try to...
  6. Replies
    12
    Views
    1,481

    You should take the reading in the water. 8...

    You should take the reading in the water.

    8 psi boost on the trailer seems to be abnormally high. You should not be revving the motor on the trailer in the first place. Itís not good for the...
  7. Replies
    12
    Views
    1,481

    Put a boost gauge on and take a reading at 4700...

    Put a boost gauge on and take a reading at 4700 RPM and report back.
  8. read this thread for hook up.... ...

    read this thread for hook up.... http://greenhulk.net/forums/showthread.php?t=95814
  9. Replies
    23
    Views
    7,571

    If the tach was showing an RPM then the ignition...

    If the tach was showing an RPM then the ignition pulse would be OK. Did it show an RPM when cranking it over? The crank and cam sensor are both magnetic type so not much to go wrong there, you most...
  10. Use a hose to check the one way valve. water...

    Use a hose to check the one way valve. water should only flow in one direction. They clog with sand normally. For the stator filter use the advice of the manual below.

    Check the cooling water...
  11. On this page above under “order OEM parts”. ...

    On this page above under “order OEM parts”. item 16 $1.98 ea.
  12. View Post

    Itís called a joint seal and is a replacement part. Check your exact model for part number.


    http://www.2wheelpros.com/oem-parts/images/honda.gifManufacturerBrand New, Genuine Honda...
  13. Replies
    2
    Views
    1,227

    Make sure you have registration and read the...

    Make sure you have registration and read the owners manual.
  14. Replies
    4
    Views
    1,131

    As part of the maintenance procedure is to...

    As part of the maintenance procedure is to inspect the exhaust anode would and replace as necessary óthe turbo charged models have one in the turbo housing and also one in the exhaust housing right...
  15. Replies
    6
    Views
    2,481

    Not a common problem. Sounds like the ski was...

    Not a common problem. Sounds like the ski was not maintained well. Could of cracked from not being winterized correctly. Anything can be welded but, it is double walled and would be tricky. If the...
  16. Replies
    2
    Views
    677

    Sparkplug= 9ft/lbs 6mm flange bolt= 7ft/lbs ...

    Sparkplug= 9ft/lbs 6mm flange bolt= 7ft/lbs Everything is in the shop manual.
  17. F12x has a bilge pump built in. That’s why you...

    F12x has a bilge pump built in. That’s why you didn’t see any water. Do you ride in saltwater?
  18. The tool is nice but you can use a standard...

    The tool is nice but you can use a standard feeler gauge and check the coupling to coupling face clearance (face flatness) in 4 (90) degree places.


    I would be more concern on- Why the seal...
  19. Replies
    4
    Views
    1,310

    It goes out several places. There is also a...

    It goes out several places. There is also a check valve that controls some of the routing. Get a service manual and follow the coolant hose routing to understand more. It will show you everything.
  20. Replies
    4
    Views
    1,310

    It outputs to the pilot tube. That's the ...

    It outputs to the pilot tube. That's the (Pisser out back)
  21. Replies
    2
    Views
    665

    02-03 years just vent to atmosphere. Later years...

    02-03 years just vent to atmosphere. Later years to the air box.
  22. Replies
    10
    Views
    4,114

    Put a boost gauge on and take a reading at 4700...

    Put a boost gauge on and take a reading at 4700 RPM and report back.
  23. Replies
    2
    Views
    841

    Your post is not clear. The WGS (waste gate...

    Your post is not clear.

    The WGS (waste gate solenoid) if the hose is disconnected will not cause the ski to "overboost" However, disconnecting the WGA (waste gate actuator) Will cause the ski to...
  24. Start by checking out the main relay per the...

    Start by checking out the main relay per the procedure in the service manual. There are also fuses inside the relay box to check, then the stop circuit would be my next step.
  25. Replies
    10
    Views
    4,114

    Be sure the turbo wastegate "hose restrictor" is...

    Be sure the turbo wastegate "hose restrictor" is in the correct location.



    .
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4