Search

Search: Search took 1.00 seconds.

  1. When Randys asks if it's loading up? That's a...

    When Randys asks if it's loading up? That's a common term for the engine getting too much fuel at idle and takes a few moments for the engine to accelerate. When you hit the throttle the ski fails...
  2. www.Watcon.com has Polaris specific carburetor...

    www.Watcon.com has Polaris specific carburetor rebuilt kits using genuine Mikuni parts, and just the parts you need for a Polaris carb.

    Fuel pump kit is sold separately
  3. Engines start easily on the trailer as there's no...

    Engines start easily on the trailer as there's no load on it and require little fuel. (like neutral in a car) When you start it in the water, it has a load and generally requires more fuel. So your...
  4. Replies
    42
    Views
    4,442

    Nice job on the re-do. Try CAREFULLY taking a...

    Nice job on the re-do.

    Try CAREFULLY taking a heat gun to your rub rails. The heat will bring the oils back to the surface and revive the color. Just don't stay in one spot too long or you'll burn...
  5. Replies
    42
    Views
    4,442

    I'd be leary of the fuel hose used on this one....

    I'd be leary of the fuel hose used on this one. If it's already used and still soft, you're good to go. If it's used and somewhat rigid, it will get hard and most likely crack. If the hose is new,...
  6. Replies
    42
    Views
    4,442

    post a pic of the old one showing the top of the...

    post a pic of the old one showing the top of the tank, I might have a yard queen fitting that description. Shipping as you know on something that bulky ain't gonna be peanuts
  7. Replies
    42
    Views
    4,442

    Correct. Just splice the new wire to the old and...

    Correct. Just splice the new wire to the old and it should work just fine
  8. Replies
    42
    Views
    4,442

    The Polaris fuel tank level sender is not...

    The Polaris fuel tank level sender is not connected to 12 volt power, at all.

    The sender is powered via the MFD display, using a special circuit with very low voltage (circa 2.x volts) and very...
  9. Replies
    42
    Views
    4,442

    "For the filters I was referring to the ones that...

    "For the filters I was referring to the ones that are in the actual tank." Sorry, my bad. Misread what you were after. I tried searching around for an answer, for the lengths but came up empty. ...
  10. Replies
    42
    Views
    4,442

    As far as the wiring, I'd respectfully disagree...

    As far as the wiring, I'd respectfully disagree on the battery switch guess. Those wires are WAY too small to be any kind of a battery cutoff. You're likely looking at the remnants of something...
  11. Replies
    42
    Views
    4,442

    Welcome. Do you want to remove the key thing...

    Welcome.

    Do you want to remove the key thing entirely and revert to the factory wiring configuration?

    Or do you want to still have the key switch and figure out how to wire it into the system...
Results 1 to 11 of 14