Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    6
    Views
    277

    Have you tried the trim system troubleshooting...

    Have you tried the trim system troubleshooting procedure as specified in the service manual?
  2. Replies
    6
    Views
    277

    It's been a while since I last worked on one of...

    It's been a while since I last worked on one of those.

    You're saying that the trim indicator doesn't move? Do you have a service manual? The trim will only work when the engine is running, or...
  3. OEM had spacers on both sides of the rod. Some...

    OEM had spacers on both sides of the rod. Some aftermarket pistons don't use the spacers. Did your pistons come with instructions? My Pro-X pistons do not use the spacers.
  4. Replies
    9
    Views
    483

    Start by checking everything you can that doesn't...

    Start by checking everything you can that doesn't cost anything. Check the battery voltage. Try a known good battery.

    You can pull the fuel rail and check the injectors by removing just two...
  5. Replies
    9
    Views
    483

    Welcome aboard, Jeff! Why did you replace the...

    Welcome aboard, Jeff!

    Why did you replace the starter relay if it was cranking?

    Are you getting fuel out of the injectors? Pull the fuel rail/injector assembly off and crank it. You should...
  6. Replies
    3
    Views
    374

    I have not done this, but someday I may attempt...

    I have not done this, but someday I may attempt it on my Kawasaki Jet Mate boat. I would think that an oscillating tool (Fein Multimaster or similar) would probably be the best choice.
  7. Yes, I'm biased, but my favorite cart is the one...

    Yes, I'm biased, but my favorite cart is the one I designed and built: http://greenhulk.net/forums/showthread.php?t=282648
  8. That's interesting. I don't think I've ever...

    That's interesting. I don't think I've ever taken my airbox apart. Guess I'll have to. My nephew is rebuilding his 150 engine, maybe I can take a look at that this week.
  9. Replies
    9
    Views
    490

    I don't know if he's talking about spark plugs or...

    I don't know if he's talking about spark plugs or coil plugs.
  10. Replies
    9
    Views
    490

    Did you mess with the rotor when you had the...

    Did you mess with the rotor when you had the engine out??? If not, and it was running good before, I don't think that's your problem.

    See what smokeysevin thinks about it before you tear into it....
  11. http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=481099&stc=1 http://greenhulk.net/forums/attachment.php?attachmentid=481100&stc=1 ...
  12. The brass tabs are some sort of adaptors that...

    The brass tabs are some sort of adaptors that come packaged with a new battery. Not sure what they are used for.

    The cutouts on the rubber seals should face the exhaust pipe. Your's are...
  13. Replies
    9
    Views
    490

    Coil wires plugged in tightly?

    Coil wires plugged in tightly?
  14. Replies
    13
    Views
    266

    Good point! On the rare occasions when I've had...

    Good point! On the rare occasions when I've had a leak, it became obvious that something was wrong because the engine ran poorly from breathing water spray, or the 'Ski just started handling weird.
  15. Replies
    14
    Views
    378

    Ideally, a compression tester would have an...

    Ideally, a compression tester would have an electronic probe and no hose to change the combustion chamber volume at all. I've looked and have not found one like this.

    Another alternative might be...
  16. Replies
    13
    Views
    266

    My electric bilge pumps exit out the side. ...

    My electric bilge pumps exit out the side. However, I really don't think it matters. If you're riding fast enough for the factory siphon bilge system to work, the hull will stay dry inside. If you...
  17. Replies
    0
    Views
    114

    Alternative Fuel Filter For Older STXs

    The Kawasaki high pressure fuel filter (between the pump and fuel rail) sells for $49. It looks suspiciously like an automotive filter, and I've found one that fits for half that price. The part I...
  18. Replies
    3
    Views
    263

    They should be just fine.

    They should be just fine.
  19. Replies
    14
    Views
    2,667

    The way to solve the water in the footwells...

    The way to solve the water in the footwells problem is to drill drain holes at the lowest point and run hoses from them to holes in the bottom of the hull. Yamaha started doing this on some of their...
  20. Thread: Jetski cover

    by steve45
    Replies
    12
    Views
    1,264

    Kawasaki and Yamaha both use the same supplier,...

    Kawasaki and Yamaha both use the same supplier, Commercial Sewing. They used to use a material called Sunbrella, which lasted a very long time. 20+ years ago they switched to a material called...
  21. Replies
    1
    Views
    210

    If I remember right, it is inserted into a rubber...

    If I remember right, it is inserted into a rubber block that is glued to the inside of the hull. Placement shouldn't be critical. See if there is a rubber block with a hole in it somewhere, or look...
  22. Thread: Jetski cover

    by steve45
    Replies
    12
    Views
    1,264

    Like this 3 year old cover? ...

    Like this 3 year old cover?

    http://greenhulk.net/forums/attachment.php?attachmentid=480620&stc=1
  23. Thread: Jetski cover

    by steve45
    Replies
    12
    Views
    1,264

    No more factory covers for me! ...

    No more factory covers for me!

    http://greenhulk.net/forums/showthread.php?t=239821
  24. Replies
    136
    Views
    16,914

    I was able to get it together fairly easily after...

    I was able to get it together fairly easily after I figured out the secret of removing the 4-1 pipe from the exhaust manifold. I removed the rings from the 4-1 pipe, slid it into the waterbox and...
  25. Replies
    136
    Views
    16,914

    Thanks, Sean! I just robbed a hose from my...

    Thanks, Sean!

    I just robbed a hose from my wrecked Ultra LX parts 'Ski and I'm going back together with it now. Got the 'piston rings' and grooves cleaned up. I'll give the grease a try. I hope...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4