Search

Type: Posts; User: SavageTusk

Search: Search took 0.00 seconds.

  1. I have the same question. Was this the proper...

    I have the same question. Was this the proper connector pin?
  2. Replies
    8
    Views
    390

    I ordered 3 new ones. Interesting on the...

    I ordered 3 new ones. Interesting on the silicone comment, just a small lining on the bottom seal I assume.
  3. Replies
    8
    Views
    390

    I see so we're talking about just replacing the...

    I see so we're talking about just replacing the SPARK PLUG PIPE 420851754

    That doesn't look to terribly complicated. Thanks!
  4. Replies
    8
    Views
    390

    Yeah there was a little pooled around the base. ...

    Yeah there was a little pooled around the base. Compression was when cold.
    Good to know about the gaskets.

    So 3 questions.

    1. Can I ride this season and fix it this winter or is this...
  5. Replies
    8
    Views
    390

    Oil on sparkplug threads

    I have a sea-doo 2013 GTR 215.
    When changing the plugs today, cylinder 2 had a good amont of oil on the sparkplug threads.
    The jetski runs great, no misfiring.
    Cylinder 1 & 3 have 140psi and...
  6. Seadoo spark speaker system update.

    I ended up going with a BOSS Audio MC900B (2) 6.5" in the storage bin and (2) 5.25" in the bin lid. I have the stereo and leds on 2 different waterproof toggle switches and the stereo control flush...
  7. Speaker pod rear bar mount. Seadoo gtr 215

    Does anyone know how to accomplish this? I'd like to install a couple rear facing 6.5" wake tower pod speakers on my 2013 seadoo gtr 215. This would be mainly for towing music with a rear speaker...
  8. Replies
    11
    Views
    2,717

    How did you mount the speaker pod bar? I like...

    How did you mount the speaker pod bar?

    I like that concept for pulling tubers, a simple toggle to turn the speakers on and off.
  9. Replies
    18
    Views
    7,536

    Use a 3/4" Open end wrench, common in about every...

    Use a 3/4" Open end wrench, common in about every toolbox. It fits perfectly around the rubber before the clip. press down and latch.
  10. Thanks for the placement idea, I'm against thru...

    Thanks for the placement idea, I'm against thru hull mounting too. I have 4 6.5"'s on the way, 2 will go where you have yours, and 2 on the storage bin lid. I'll post my setup when complete.
Results 1 to 10 of 10