Search

Type: Posts; User: steve45

Page 1 of 8 1 2 3 4

Search: Search took 0.92 seconds.

  1. Replies
    13
    Views
    130

    The Rhaas holder is a good one, and about the...

    The Rhaas holder is a good one, and about the same price as OEM.

    If you ride with 4200 to seal the holder, the first time you hit a wave and come down, the pressure in the pump shoe area will...
  2. Replies
    14
    Views
    213

    The trailer most likely came with a tag giving...

    The trailer most likely came with a tag giving it's specs, but after 27 years, it may be missing or illegible. Registration paperwork may give you a clue.

    The dry weight of your 'Ski is about 755...
  3. Replies
    3
    Views
    96

    Welcome aboard, hpux1560! No, letting it sit...

    Welcome aboard, hpux1560!

    No, letting it sit for years was not a good idea.

    Why was the starter corroded? Was there water inside the hull?

    If you remove the spark plugs you should be able...
  4. Replies
    6
    Views
    101

    Does it have any oil in it?

    Does it have any oil in it?
  5. This thread shows what I found on an STX-12F...

    This thread shows what I found on an STX-12F harness: http://greenhulk.net/forums/showthread.php?t=281195
  6. Replies
    6
    Views
    101

    The pop-off valve on that carb is probably...

    The pop-off valve on that carb is probably seeping, allowing hydrostatic pressure from the oil tank to flood the carb. You might try cleaning it with solvent and applying light pressure to both...
  7. Replies
    9
    Views
    295

    The STX and Ultra LX are not supercharged. The...

    The STX and Ultra LX are not supercharged. The Ultra 310 LX is, and your 260 is.
  8. Replies
    128
    Views
    15,683

    Here we go again! This time it's a 2000 1100 ZXi...

    Here we go again! This time it's a 2000 1100 ZXi for only $4800! Engine rebuilt by 'master mechanics at Dale's Jet Sports in Sachse Texas'. Does 'close to 70 MPH' with trim stuck in full up...
  9. Pull ALL the connectors apart in the wiring...

    Pull ALL the connectors apart in the wiring harness and check for corrosion. I found a termination plug in my STX-15F that was corroded from laying in water in the bottom of the hull. That didn't...
  10. Replies
    8
    Views
    219

    I don't think there is much room at all, but you...

    I don't think there is much room at all, but you can use a 1/4" hex bit and a 1/4" wrench to turn it. Just don't drop the bit!
  11. I was talking about the ground wire, not the...

    I was talking about the ground wire, not the positive wire.

    Are you talking about jumping from the + battery terminal to the starter terminal?
  12. There is someone around here that can match a key...

    There is someone around here that can match a key to your existing ECM. I just can't remember who.

    Do a search.
  13. Replies
    8
    Views
    219

    Yes, clockwise is leaner.

    Yes, clockwise is leaner.
  14. Replies
    8
    Views
    219

    If anything, the plugs look a bit rich. Usually...

    If anything, the plugs look a bit rich. Usually it has to be very rich for it to die. How did you check the plugs? Did you idle back to shore, or did you shut it off during a high speed run and...
  15. Replies
    10
    Views
    161

    OK, the stinger mod cuts flow to the exhaust, but...

    OK, the stinger mod cuts flow to the exhaust, but the water enters after the temp sensor.
  16. Welcome aboard, PALakeGuy! I presume you...

    Welcome aboard, PALakeGuy!

    I presume you turned on the orange key, right?

    Should just come on. You may have to push the Mode button to get the info you want.

    Is the battery hooked up...
  17. Welcome aboard, Oleg! I've got an early...

    Welcome aboard, Oleg!

    I've got an early STX-15F, and I had an STX-12F. Both of them had the ground wire attachments re-worked before I bought them. I never figured out why, but it was obvious...
  18. I know the feeling! You'll have it finished...

    I know the feeling! You'll have it finished before I finish my airplane. Every week I find another part I need to order. One day I just laid under it for 2 hours wondering how in the hell I'm...
  19. Replies
    10
    Views
    161

    At speed, the pissers should be spraying...

    At speed, the pissers should be spraying abundantly. And the water coming out should be about as hot as you can stand to put your hand in, perhaps warmer.

    Look for blockage in the hose from the...
  20. Replies
    12
    Views
    474

    I'm not so worried about the speedo, more...

    I'm not so worried about the speedo, more concerned about the odometer when we go cruising. I've had a lot of trouble with the paddlewheel in the rideplate on the 2013. It spins freely, but...
  21. Replies
    3
    Views
    1,760

    Which boat do you have, Buckwheat?

    Which boat do you have, Buckwheat?
  22. Replies
    8
    Views
    219

    Have you checked the fuel filter? Were the...

    Have you checked the fuel filter? Were the internal filters in the carbs cleaned?

    The plugs don't look like it was running lean.
  23. Looks like you're getting close!

    Looks like you're getting close!
  24. Replies
    12
    Views
    474

    No, SLO key is in the safe at home.

    No, SLO key is in the safe at home.
  25. Replies
    3
    Views
    85

    Yes, but you have to cut the ends off of the...

    Yes, but you have to cut the ends off of the bars, cut alignment notches in the bars, and figure out a plug arrangement. Read the thread.

    EDIT: My apologies! I thought I did a write-up on...
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4