Search

Type: Posts; User: jakber

Page 1 of 8 1 2 3 4

Search: Search took 0.01 seconds.

  1. Replies
    30
    Views
    1,998

    yes that was water and oil mixed, i got...

    yes that was water and oil mixed, i got everything cleaned up and replaced the woodruff key, balancer bearings, starter clutch ect.
    i went to check the checkvalves inside the case, the spray end of...
  2. Replies
    30
    Views
    1,998

    i think they probably forgot to add oil up front...

    i think they probably forgot to add oil up front when they pulled the starter, i took the crank out and split the cases ect, rear balancer is trashed it got full of water and ruined the bearings, but...
  3. Replies
    30
    Views
    1,998

    only enough to fully soak a single bounty paper...

    only enough to fully soak a single bounty paper towel, definitely think low oil was a part of the problem, if i remember correctly he said something about a new starter since one got burned up...
  4. Replies
    30
    Views
    1,998

    i forgot to check the sight glass before i pulled...

    i forgot to check the sight glass before i pulled the starter, but i noted that there wasnít much oil coming out of it when i pulled the starter. do you think that could be a cause for the issues iím...
  5. Replies
    30
    Views
    1,998

    i found the bearings for the balancer for less...

    i found the bearings for the balancer for less than $10 so iíll replace them, and on ebay the one way clutch is $100-150 so as long as i can get them on and off the crank i should be good. does this...
  6. Replies
    30
    Views
    1,998

    i think a different mechanic from before did that...

    i think a different mechanic from before did that one and charged him for a top end cause thatís what he told me is that it had a new top end, im gonna figure out what brand of piston the other two...
  7. Replies
    30
    Views
    1,998

    that was my bad i just put it back real quick so...

    that was my bad i just put it back real quick so i could take a picture to remember where it all went and forgot to align them.
  8. Replies
    30
    Views
    1,998

    battery was in good condition, found the issue in...

    battery was in good condition, found the issue in the one way clutch, and the beating for the counterbalancer is junk al gonna split the cases and continue, basically the one way clutch has a spot in...
  9. Replies
    30
    Views
    1,998

    got the engine pulled out and pulled the heads,...

    got the engine pulled out and pulled the heads, 1&2 the wash looks lean to me, correct me if iím wrong, and 3 has some minor scoring, not sure if i need to replace it or not yet. also thereís three...
  10. Replies
    30
    Views
    1,998

    spins both ways with starter installed, has...

    spins both ways with starter installed, has resistance and makes a noise going the wrong way though, iíll try to attach a video again. iíll get the ski into the actual garage soon and pull the motor,...
  11. Replies
    30
    Views
    1,998

    aight so i pulled the starter, the gears in there...

    aight so i pulled the starter, the gears in there felt fine but when i pulled the plugs i could spin the engine both ways by hand, if i remember correctly that means the starter clutch/bendix on this...
  12. Replies
    30
    Views
    1,998

    i uploaded 2 better videos (i think) of the...

    i uploaded 2 better videos (i think) of the sound, to me it almost sounds like a gear is not meshing inside, ill pull the starter out tomorrow and feel the gears and see how they are. if theres...
  13. Replies
    30
    Views
    1,998

    noise is coming from the motor, he said it still...

    noise is coming from the motor, he said it still runs but i didnt want to crank it for super long to get it started, the noise is during turning over but later lll put a little premix down the carb...
  14. Replies
    30
    Views
    1,998

    bad sound coming from ultra 150

    2000 ultra 150, iíll figure out how to attach video of the sound but basically while itís cranking with the plugs in itís acting like itís skipping and making a clunky/grinding sound, but spins fine...
  15. Replies
    6
    Views
    596

    there should be a rubber cap on there, hose clamp...

    there should be a rubber cap on there, hose clamp probably broke and let it go, thatís the port where you hook up a hose to run it on land, just get a rubber cap and double clamp it and it should be...
  16. Thread: 99 Ultra 150

    by jakber
    Replies
    25
    Views
    2,023

    100-120 is the recommended number, but make sure...

    100-120 is the recommended number, but make sure theyíre all the same. check the oil lines and make sure that theyíre not brittle or leaking, the oil tanks tend to leak around the sensor, and check...
  17. Replies
    10
    Views
    1,443

    Next time that happens try pulling the choke. It...

    Next time that happens try pulling the choke. It sounds like an air leak or a stick starter solenoid. The solenoid is in a box right behind the battery, theyíre cheap and easy to replace if the...
  18. View Post

    Thatís only for the head fittings, the pissers should be ok as long at theyíre not too small, I think I used some 3/8Ē from ada, but I donít think it matters, in the wintertime I run the hoses...
  19. The stinger just gets discharges right next to...

    The stinger just gets discharges right next to the one for the heads so I donít see any reason why you couldnít run it that way
  20. Thread: 2000 ultra 150

    by jakber
    Replies
    0
    Views
    1,797

    FS 2000 ultra 150

    2000 ultra 150 for sale, 212 hours, rebuilt and in good condition, my personal ski, if interested pm me or contact through Craigslist, thanks!...
  21. View Post

    Itís up to you on just servicing or upgrading, if youíre gonna upgrade Iíd recommend sending it to groupK for a blueprint if youíre gonna send it to be upgraded. A solas 16/20 would be good too, and...
  22. View Post

    That whining is your pump, if itís never been rebuilt itís long overdue for a rebuild.
  23. 452369 the circled bit is there starter relay and...

    452369 the circled bit is there starter relay and thatís whatís clicking, if you can get a genuine Kawasaki relay thatíd be the best way to go for replacement, as the other brands donít last. Make...
  24. Replies
    2
    Views
    389

    Ultra 150 exhaust leak/hose

    Anyone know where I can get the section of rubber hose that runs from the stinger to the water box? I have a big hole in mine and itís in need of replacement. Thanks!!!
  25. Replies
    9
    Views
    3,010

    i always put in at pace bend or briarcliff. pace...

    i always put in at pace bend or briarcliff. pace bend will be cheaper. that end of the lake is very calm especially after the split. next to pace bend is cow creek which is my favorite cove, very big...
Results 1 to 25 of 191
Page 1 of 8 1 2 3 4