Search

Search: Search took 1.00 seconds.

  1. I've heard good things about these plastic strips...

    I've heard good things about these plastic strips you can screw to your bunks to assist in loading/unloading. Buddy says it would slide off the trailer if it wasn't attached. Haven't tried them, but...
  2. Replies
    18
    Views
    14,149

    That's my logic exactly. Why replace the wear...

    That's my logic exactly. Why replace the wear ring when you have to refurb the prob anyway.

    So from my readings, I deduce that the SS lined rings are no good, and I should go for the solid SS...
  3. Replies
    18
    Views
    14,149

    Here's my take on it. If you suck up something...

    Here's my take on it. If you suck up something large enough to damage the prop, you have to replace the plastic wear ring regardless. But chances are, a stainless ring will be okay. It costs less...
  4. Sticky: you should be okay

    I believe the 03's are affected. They say that any valve with part number that starts with 72 (I believe) has hollow exhaust valves. The non-supercharged engines aren't as susceptible to this issue...
  5. Sticky: Sounds like you're on top of things. Just make...

    Sounds like you're on top of things. Just make sure your switch is waterproof. I had trouble with mine. They tend to short out, especially when salt hits them. I've even had a few "marine" switches...
  6. Replies
    80
    Views
    14,121

    But costs waaaaaaay less!

    But costs waaaaaaay less!
  7. Replies
    15
    Views
    16,512

    Here is the maiden voyage....

    Here is the maiden voyage. https://www.youtube.com/watch?v=iZ29xc4-IzE I've upgraded several things since then, like a better rectifier location, widened the reduction and steering nozzles and other...
  8. Replies
    7
    Views
    1,236

    Interesting. I will look. Better, I will test by...

    Interesting. I will look. Better, I will test by spraying a bit of carb cleaner around the seams. I will have to somehow plumb my intake out of the engine bay, as the fumes will definitely affect how...
  9. I was attentive to spray down the carbon ring...

    I was attentive to spray down the carbon ring with soapy water every 30 sec or so, and it's actually a leaky oil cooler
  10. Replies
    74
    Views
    5,712

    Blowing through all the galleys yields no...

    Blowing through all the galleys yields no particles
  11. Replies
    74
    Views
    5,712

    Connecting rod and crank bearings both at. 001in,...

    Connecting rod and crank bearings both at. 001in, way below service limit. A few very shallow and thin groves. Very light making. All in all, everything looks pretty good...
    384465384466384467
  12. Replies
    74
    Views
    5,712

    Aluminum in the oil was an extremely fine powder....

    Aluminum in the oil was an extremely fine powder. It was dissolved and just looked like silver particles evenly dispersed in the oil. It made little patterns as the oil was draining over the screen....
  13. Replies
    5
    Views
    2,501

    Thanks guys!

    Thanks guys!
  14. Thread: EGT Gauges

    by IDoSeaDoo
    Replies
    11
    Views
    4,220

    Picked up the Koso gauges for $200 on eBay....

    Picked up the Koso gauges for $200 on eBay. Tapped a pipe thread in my stock exh. manifolds by shaving those two square tabs on the side and drilling right into them. Picked up a 3/16 compression...
Results 1 to 14 of 14