Search

Type: Posts; User: casey67

Page 1 of 8 1 2 3 4

Search: Search took 0.03 seconds.

  1. Exactly.

    Exactly.
  2. Corroded. Spray some sort of penetrant at front...

    Corroded. Spray some sort of penetrant at front of stator and before pump base. Let soak overnight. Could bang the sides with a rubber mallet.
  3. What you are describing does not make sense ....

    What you are describing does not make sense .
    Look up diagrams here ; https://parts.polarisind.com/Browse/Browse.asp

    Post a picture of what you are talking about.
  4. What is the back story on this craft ? Original...

    What is the back story on this craft ?
    Original owner ? Original engine ? Oil pump ?

    Look closely at the oil pump to see if you can find a part number.
    Cross reference here :...
  5. Post a picture of what you are working on.

    Post a picture of what you are working on.
  6. Need to know exact voltage while cranking on...

    Need to know exact voltage while cranking on red/purple CDI wire.
  7. Post a picture of your oil pump.

    Post a picture of your oil pump.
  8. Replies
    10
    Views
    1,428

    FS - Parts Sold out.

    Sold out.
  9. Replies
    7
    Views
    104

    If you look at the baffles, each one has a large...

    If you look at the baffles, each one has a large flow through path. Exhaust can and will flow through quickly. Sound waves will bounce around and soften. Most car mufflers I've seen are a simple...
  10. Replies
    4
    Views
    130

    Install it and tell us what difference it makes....

    Install it and tell us what difference it makes. I'm guessing little difference.

    Changing the stator as an assembly could be done in minutes-it shouldn't stop the project from moving forward.
  11. Replies
    8
    Views
    115

    Correct, no gasket on case halves. Sealant is...

    Correct, no gasket on case halves. Sealant is mentioned in service manual and discussed on forum.
  12. Replies
    8
    Views
    115

    I dont think it is the fuel pump or the actual...

    I dont think it is the fuel pump or the actual reed valves, The reed valve housing has 2 rubber seals that may leak air,carb gaskets, crappy case sealer, or crank seals. Probably best to pressure...
  13. Replies
    8
    Views
    115

    https://parts.polarisind.com/Browse/Browse.asp ...

    https://parts.polarisind.com/Browse/Browse.asp

    According to the parts list, it does have a 3 position fuel switch.
    In the "ON" position it draws gas 2/3 the way down into the tank.So that when it...
  14. Replies
    10
    Views
    13,036

    Did you perform the 9v battery test outlined in...

    Did you perform the 9v battery test outlined in the service manual ?

    Would like to know your cranking volts on red/pur and brown wires at CDI.
  15. Replies
    8
    Views
    115

    What the compression on the Mag cyl, throttle...

    What the compression on the Mag cyl, throttle open.

    What is a "throttle runaway " ? Engine should rev with throttle applied.

    The only time I had extremely high idle speed was when fuel level...
  16. Replies
    3
    Views
    79

    https://parts.polarisind.com/Browse/Browse.asp ...

    https://parts.polarisind.com/Browse/Browse.asp

    To see what was used by Polaris.
    Why there are that many orings, you would need to ask the people that sold it and that probably will not be...
  17. Replies
    14
    Views
    591

    Which service manual are you looking at ? The...

    Which service manual are you looking at ?
    The Direct Injection stator is totally different from the carb models stator.
    There are 2 different and seperate wiring diagrams and diagnosis.
    From my...
  18. 5400 is about where they run on 2 cylinders. An...

    5400 is about where they run on 2 cylinders. An inline spark tester for a ride might help with intermittent issue.
    That center carb was HIGHLY suspect when you said the plug was white, did you find...
  19. Replies
    9
    Views
    186

    Did you closely clean and inspect the fuel return...

    Did you closely clean and inspect the fuel return fitting and passage ?
  20. https://parts.polarisind.com/Browse/Browse.asp

    https://parts.polarisind.com/Browse/Browse.asp
  21. Replies
    8
    Views
    2,152

    The low speed mixture screws are for "fine...

    The low speed mixture screws are for "fine tuning" mixture.
    Polaris did list a starting point but added the mixture needs to be checked.

    Now that these are 23 years old, all engines will have...
  22. Replies
    2
    Views
    61

    No. The wires are for RPM limiter,rverse switch...

    No. The wires are for RPM limiter,rverse switch if equiped. Not used on the 700 Virage.
  23. Shows using a 202. Really similar and will work....

    Shows using a 202. Really similar and will work.
    https://parts.polarisind.com/Assemblies.asp
  24. Replies
    6
    Views
    214

    98 SLTH does not have mid range anything. Last...

    98 SLTH does not have mid range anything.
    Last 2 digits in HIN are the year.
    Post picture of carbs you are working on.
  25. Replies
    5
    Views
    150

    The 3cyl coils work exactly the same. It will...

    The 3cyl coils work exactly the same. It will work with the gen1 ignition,
    The spark plug wires are completely different and will not attach properly.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4