Search

Page 1 of 16 1 2 3 4

Search: Search took 1.00 seconds.

  1. Replies
    32
    Views
    3,088

    the parts diagram you keep asking for is clearly...

    the parts diagram you keep asking for is clearly annotated in a Shop Manual, https://brpmanuals.com/.
  2. Replies
    15
    Views
    454

    Clearly the previous owner had issues with this,...

    Clearly the previous owner had issues with this, if it was mine I would install a 300 ski stator which has higher power amperage and solid wires straight to the VR.
  3. Since you have verified the ECM and sensors are...

    Since you have verified the ECM and sensors are not the issue, it is time to pull the engine AGAIN and remove the PTO housing, oil pumps, springs, etc and find out what is going on.
  4. Replies
    15
    Views
    454

    There are 3 yellow wires coming from the back of...

    There are 3 yellow wires coming from the back of the PTO housing from the stator. This is what generates power to the VR. There is a connection half way on the right side you need to check for...
  5. Replies
    13
    Views
    2,111

    There are a lot of us on this forum that have...

    There are a lot of us on this forum that have taken the impeller nose cone off, and have been running for many years without one.

    You will gain 0.69 mph running without it!
  6. You guys really need to provide year and model...

    You guys really need to provide year and model info to help diagnose problems.

    The 2009 and older skis have Siemens ECUs and MPEMs that indicate different problems. The newer Bosch ECUs are more...
  7. Replies
    33
    Views
    4,475

    https://www.defender.com/product3.jsp?name=scandvi...

    https://www.defender.com/product3.jsp?name=scandvik-aba-316-hose-clamp-cruiser-pack&path=-1|2243574|2243584&id=1871613

    Not AWAB but just as good in quality.
    ...
  8. Replies
    33
    Views
    4,475

    I have replaced several oetiker clamps over the...

    I have replaced several oetiker clamps over the years like oil cooler, fuel lines, PTO bearing seal, etc, but I did put my oetiker pliers on every clamp I could find. Unfortunately, OEM quality...
  9. Replies
    33
    Views
    4,475

    I have never had an Oetiker clamp fail on...

    I have never had an Oetiker clamp fail on anything. I replaced all my OEM clamps with AWAB SS and have not had any loose clamp issues since. I tried the T-clamps also, but prefer the AWABs.
  10. Replies
    2
    Views
    201

    There are 3 yellow wires coming from the rear PTO...

    There are 3 yellow wires coming from the rear PTO housing from the stator, with a connection 1/2 way to the VR. Check that connection for corrosion and continuity to the VR. It is a common failure...
  11. Replies
    13
    Views
    1,748

    91 mph scared the shit out of me, 98 mph is just...

    91 mph scared the shit out of me, 98 mph is just sick on a rec ski!

    Well done, now slow it back down before you kill yourself.
  12. Thread: water strainer

    by jpt7779
    Replies
    7
    Views
    765

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=473778&stc=1

    Not a 2021 but a 2010 T-X.

    Here is what I installed. Red handle valve is main shutoff valve for emergency towing, next is my...
  13. Replies
    9
    Views
    587

    I agree with Jerry about staying with 15/19, BUT...

    I agree with Jerry about staying with 15/19, BUT I would be more concerned about WHY the splines stripped. If you have the original OEM drive shaft that is the source of your problem. The 2010-2011...
  14. The most important tool you need is a Shop...

    The most important tool you need is a Shop Manual, https://brpmanuals.com/seadoo-manual.htm, get the
    2011 RXT/RXP manual. The 2010 manual does not exist in pdf format, but the 2011 skis are...
  15. Replies
    14
    Views
    1,374

    Marc, I think we discussed this but I would,...

    Marc,

    I think we discussed this but I would, REPLACE the IAT and MAP sensors. The throttle body is very likely messed up due to its history. Do a search and you will find a VW throttle body that...
  16. Replies
    28
    Views
    4,120

    I have done all my own maintenance since 2005 and...

    I have done all my own maintenance since 2005 and is FAR cheaper and you know it will be done correctly.

    Oil filter $12, O-rings $8, 4 quarts of oil (which you will typically only use 3.5qts) $32,...
  17. The OEM drive line components you should be...

    The OEM drive line components you should be looking for are 2012-2015 RXT-X and are readily available using the OEM Parts link above.
  18. Here is what I did and still running strong:...

    Here is what I did and still running strong: http://greenhulk.net/forums/showthread.php?t=227324
  19. Replies
    18
    Views
    1,777

    And you have 2300+ posts and come across as a...

    And you have 2300+ posts and come across as a smart ass frequently!
  20. Replies
    3
    Views
    378

    Use this kit from Riva to keep OPAS in the up...

    Use this kit from Riva to keep OPAS in the up position all the time:

    https://rivaracing.com/i-17283738-riva-sea-doo-opas-competition-kit.html

    Solves your problem. I have had this on our 05 GTX...
  21. Replies
    1
    Views
    257

    My 2010-2011 manual says “approximately 50 VAC”...

    My 2010-2011 manual says “approximately 50 VAC” at 4000 rpm. There are also 2 other tests, Continuity and Insulation.
  22. Replies
    5
    Views
    568

    8040 rpm is the limiter and has been for many...

    8040 rpm is the limiter and has been for many years. Momentary overshoots above and below are completely normal.What you are seeing is normal.

    Read this Sticky thread, it is old but still...
  23. Replies
    6
    Views
    627

    The first tool you need is a Shop Manual,...

    The first tool you need is a Shop Manual, www.brpmanuals.com.

    The 2010 RXT-X manual in pdf does NOT exist, get a 2011 RXT-X manual as they are exactly the same.

    All parts can be found right...
  24. Replies
    28
    Views
    2,662

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=466857&stc=1

    This is my M130 setup showing the electronic boost controller behind it and the plumbing from the GRF Turbo.

    The Black Beast...
  25. Replies
    28
    Views
    2,662

    http://greenhulk.net/forums/attachment.php?attachm...

    http://greenhulk.net/forums/attachment.php?attachmentid=466853&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=466852&stc=1http://greenhulk.net/forums/attachment.php?attachmentid=466851&s...
Results 1 to 25 of 400
Page 1 of 16 1 2 3 4