Search

Type: Posts; User: nmpeter

Page 1 of 8 1 2 3 4

Search: Search took 0.07 seconds.

  1. Replies
    4
    Views
    197

    Ya, you never know if a bit of the intercooler...

    Ya, you never know if a bit of the intercooler broke off and is stuck on a valve seat

    You could also put a teaspoon of motor oil in #1 to see if there is any improvement, which would point to...
  2. Replies
    6
    Views
    105

    Best part is the sale fails (doubtful) the new...

    Best part is the sale fails (doubtful) the new tank and fuel pump will serve me well

    I was toying with the idea of starting some work in my 4x4 (like some fresh paint and fixing the seat and...
  3. Thread: 3D printing

    by nmpeter
    Replies
    2
    Views
    66

    View Post

    Iíd like to dabble in some 3d printing

    Advice/suggestion welcome

    Lots of info out there, so much that I deem it questionable in quality so I havenít gotten close to pulling the trigger on a...
  4. Replies
    6
    Views
    105

    Ouch $1200 is painful and I can take a few days...

    Ouch $1200 is painful and I can take a few days of pain to avoid losing that much selling my jeep for half price

    Moral of the story here folks

    Fuel pump life gets cut when you run the tank...
  5. Replies
    3
    Views
    128

    pulling the engine for a bottom end bearing...

    pulling the engine for a bottom end bearing inspections was a wise move

    I'd still try to run a compression test, before cracking the engine cases, just to be sure of what you are going to be...
  6. Replies
    6
    Views
    105

    I'm taking it the wrong way this time

    so sit back and listen to this wonderful tale of "unobtanium"

    My 94 jeep Cherokee which I parked a few years ago is being sold

    its a nice little truck, but with business being practically...
  7. I'd go high NADA book value retail and then add...

    I'd go high NADA book value retail and then add 10% for tough covid market and another 10-15% for the logbook

    of course you could settle for less but that's what my initial ask price would be...
  8. Replies
    4
    Views
    277

    there is a specific warning in the manual about...

    there is a specific warning in the manual about the installation of the driveshaft bearing boot clamp on the pto to prevent exactly this problem, assuming of course you aren't talking about the...
  9. Replies
    3
    Views
    128

    safe to assume that when that asshat that did the...

    safe to assume that when that asshat that did the service left the main water feed hose unattached, the attention to detail in installing the oil filter was also less then perfect.

    so I'm...
  10. those numbers look darn good considering your...

    those numbers look darn good considering your circumstance.

    at worst, the end of that engine will come 3.7254 hours sooner then previous

    according to extended calculations I ran on my TRS-80
  11. Id say you may have had a critter problem...

    Id say you may have had a critter problem suddddenly

    are you getting any rpm reading on the console when you crank the engine?

    and exactly what parts of the ski were assembled?

    at the moment...
  12. Replies
    5
    Views
    337

    if it was the beginning of this season I'd agree...

    if it was the beginning of this season I'd agree on the $6500 price given the triton trailer

    Given the current market circumstance if somebody really wants it they best be ready to put at least 5k...
  13. Replies
    2
    Views
    183

    I'm very familiar with that kind of rock...

    I'm very familiar with that kind of rock ingestion problem

    you'll need to remove the impeller to do a full inspection

    to accomplish this you'll need a _good_ bench vise and some hand tools.
    ...
  14. pull the fuel rail, bag the injectors in gallon...

    pull the fuel rail, bag the injectors in gallon freezer ziplocks and see what happens when you crank the engine. replacing/cleaning the injectors is no big deal as you'll see as to how easy the fuel...
  15. Replies
    2
    Views
    174

    there is not a impeller wrench specific to the...

    there is not a impeller wrench specific to the spark. I was able to use one of my existing spline wrenches so my best guess is that its the small two stroke size..with he next up being for the 4-tec...
  16. Replies
    18
    Views
    913

    For tiggt spots in a fume free environment I tape...

    For tiggt spots in a fume free environment I tape some 1/2 pvc pipe to the end of the vac hose

    I cut the end of pvc to a 45 angle to allow for scrapeage

    In really tight spots a single edge...
  17. ouch, lucky indeed I'd prep a spare lanyard...

    ouch, lucky indeed

    I'd prep a spare lanyard key, and of course paint it yellow with a fairly sizeable bit of yellow nylon strap attached to it
    message of your choice stenciled onto the webbing...
  18. you deedent get the notice... they fresh out...

    you deedent get the notice...

    they fresh out of red tape in mexico

    in all seriousness I don't recall seeing anything touted about a new anti-siphon/vac break/magic gate of Aquarius to stop...
  19. Replies
    9,519
    Views
    634,010

    i was find of the $125 colt pythons myself....and...

    i was find of the $125 colt pythons myself....and the $10 sks clones
  20. at some point in the near future I should be able...

    at some point in the near future I should be able to provide top speed and rpm when this prop is installed on a 2016 rxt-x.

    lake levels permitting of course....
  21. Replies
    9,519
    Views
    634,010

    finally got the old delorean fired up after...

    finally got the old delorean fired up after sitting since 1986...

    https://www.wideopenspaces.com/time-machine-get-a-load-of-these-vintage-gun-ads/
  22. Good question! It actually first came in for a...

    Good question!

    It actually first came in for a check engine/limp mode issue

    His dealer couldnít look at it for at least a month

    He was hoping I could repair it so his family could enjoy a...
  23. Replies
    11
    Views
    336

    I'll guess 5000-6500 on price, in any event a...

    I'll guess 5000-6500 on price, in any event a solid buy

    good luck with her
  24. Replies
    6
    Views
    125

    check with m/m marine out of California, its a...

    check with m/m marine out of California, its a salvage joint



    and in regards to dealing with scammers.

    I had a scammer send me a keychain thru the mail and then claim that they shipped the...
  25. Replies
    11
    Views
    336

    go with the Kawasaki for sure and follow the...

    go with the Kawasaki for sure and follow the excellent advice here

    its fortunate that there is a great body of info available on those skis, here.
Results 1 to 25 of 200
Page 1 of 8 1 2 3 4