Search

Type: Posts; User: Hockey27925

Page 1 of 4 1 2 3 4

Search: Search took 0.00 seconds.

  1. I’m running a deans tune and I have the new turbo...

    I’m running a deans tune and I have the new turbo smart BOV
  2. going to pull it in a few weeks and see what...

    going to pull it in a few weeks and see what happens. If it is not a leaking intercooler....any other ideas on possibilities?
  3. Most of those posts regarded the stock ic, didnt...

    Most of those posts regarded the stock ic, didnt think such a quality piece from fizzle and so new would be subject to similar issues, but i guess anything is possible
  4. I have the fizzle intercooler with the dedicated...

    I have the fizzle intercooler with the dedicated line off the pump. The intercooler is fairly new...only like 15-20hrs on it tops and I highly doubt it’s leaking, plus pulling that thing isn’t much...
  5. FZS sticking throttle or leaking injector

    2016 fzs after a slow cruise with minimal throttle, when i go to crank it wide open, it will either hesitate or almost clutch up before it hauls. Throttle body recently replaced and NO codes, could...
  6. Replies
    14
    Views
    1,531

    My biller pump strainer looks very similar to...

    My biller pump strainer looks very similar to that image above. It connects off my pump and into a thru hole fitting I have drilled in the hull near the exhaust housing
  7. Replies
    14
    Views
    1,531

    Also, I have the engine power cooling kit from...

    Also, I have the engine power cooling kit from RIVA, would that work on the new 2020 pump kit?
  8. Replies
    14
    Views
    1,531

    Will that require a new shaft as well? I see a...

    Will that require a new shaft as well? I see a lot of performance parts for the FZS do not fit the 2020 GP and they usually state that you will need a new shaft or vice versa?
  9. Replies
    14
    Views
    1,531

    Would that be a better option or the riva one for...

    Would that be a better option or the riva one for $500?
  10. Replies
    14
    Views
    1,531

    Yes I have had a few different solas props in...

    Yes I have had a few different solas props in there with the various upgrades I’ve done. Is it also possible to be losing top end because of a wear ring going bad?
  11. Replies
    14
    Views
    1,531

    Wear ring 2016 FZS

    Is it common for the wear ring to be going in a 2016 FZS with 90 hours on it? Also, recommend riva stainless steel or just another stock one? The ski seems to not top out higher than 85mph as...
  12. Replies
    13
    Views
    960

    I’m up north central jersey

    I’m up north central jersey
  13. Replies
    13
    Views
    960

    Thank you I’ll give him a shout and see what he...

    Thank you I’ll give him a shout and see what he says. They were away at nationals so I went here for some insight. I am still running stock pump and nozzle
  14. Replies
    13
    Views
    960

    I didn’t gain the mph from switching props lol. ...

    I didn’t gain the mph from switching props lol. I had installed retainers and increased the rev limiter from 8750 to 9400 and also switched the props and seen the same mph. Anyways here is what I...
  15. Replies
    13
    Views
    960

    With the 13/20 I was running at 81.5mph @ 8400rpm...

    With the 13/20 I was running at 81.5mph @ 8400rpm in 70degree weather today which is a little slow for my liking. With the 13/18 I was spinning at 9400rpm but only hitting 83.8mph. I’d like to see...
  16. Replies
    13
    Views
    960

    im almost on the limiter with the 13/18

    im almost on the limiter with the 13/18
  17. Replies
    13
    Views
    960

    impeller question

    16 FZS - used to roll 8750 rev limiter on the solas 13/20 @ 83.2mph
    - now new retainers 9400 rev limiter on the solas 13/18 @83.8mph???????
  18. Rear exhaust and dedicated intercooler line worries

    Does anyone have a rear exhaust thru hull and a dedicated intercooler line? My two worries....1) hot intercooler pipe near a rubber water hose 2) drilling another (much larger hole) for the exhaust,...
  19. Replies
    3
    Views
    650

    Yamaha YDS ebay $60

    Has anyone tried using these yamaha YDS kits on eBay that sell for $60 which include the cable and dvd software?
    ...
  20. Replies
    6
    Views
    624

    FZS idle issues

    After this past winter in NJ, can get my 2016 fzs to idle right. Runs very irrattic at idle and the motor is almost shaking. You can hear it missing after hitting the throttle a few times and...
  21. Replies
    0
    Views
    199

    2016 fzs starts then shuts off

    2016 fzs starts up then shuts off right away. Mods intake, ribbon delete, fizzle with turbo smart bov, retainers, supercharger shaft kit riva, but had to throw stock computer in. Could that be it...
  22. Replies
    6
    Views
    708

    2016 FZS

    2016 FZS
  23. Replies
    6
    Views
    708

    How long on hose oil change

    Recommendations oF how long to run the ski on the hose before changing the oil?
  24. Replies
    11
    Views
    794

    Thanks for the help. Dumb dumb move on my part,...

    Thanks for the help. Dumb dumb move on my part, kept pulling instead of pushing against the spring
  25. Replies
    11
    Views
    794

    Yea that’s what I’m talking about. Any idea how...

    Yea that’s what I’m talking about. Any idea how to get the ball stub back into that hole
Results 1 to 25 of 79
Page 1 of 4 1 2 3 4