Search

Type: Posts; User: bearmedic

Search: Search took 0.00 seconds.

  1. Well, after more searching on this site, I found...

    Well, after more searching on this site, I found a recommendation by K447 to check out the big EMM connector. Low and Behold the #40 pin was broken off, still stuck in the connector!! So does this...
  2. So I ended up putting it all back together with a...

    So I ended up putting it all back together with a new gasket kit. Replaced all fuel and oil lines since I was waiting on other parts. Went to start it and it would crank but no display, no fuel pump,...
  3. So I can get a rebuilt crank from PWC Engines for...

    So I can get a rebuilt crank from PWC Engines for $400. If the pistons and jugs all look ok, would I need to replace them or would reusing them be ok? Splitting and rebuilding the bottom half looks...
  4. I've been doing tons of reading from all the...

    I've been doing tons of reading from all the helpful info on this site! I've got the service manual now too, very helpful. I think, and this may be making a mistake, but if I'm going to be doing a...
  5. Since this is my first time with this type of...

    Since this is my first time with this type of engine, I wouldn't mind doing the tear-down myself as a learning opportunity. If I start finding multiple problems, then yeah, maybe a reman engine would...
  6. Dang, that's a good point about the probable...

    Dang, that's a good point about the probable rusted bearings and I'd rather do it now than tear up the engine later. Follow-up question: with a complete rebuild in the works, would a drop-in reman...
  7. 2001 Genesis 1200 FFI Engine Recommendations

    I inherited a couple of Polaris jet skis from my brother: 1999 1050 SLX and a 2001 1200 Genesis I FFI. I've some experience with car engines but no small engine or PWC before this. My problem is with...
Results 1 to 7 of 7