19 Visitor Messages

  1. View Conversation
    Any idea what year this ski is? I have looked for pictures and can't figure it out
  2. View Conversation
    hey I just read your post about troubleshooting spark, I have a 01 slx 1200 and the only time is fires is after I unplug and reconnect the red/purple wire in the box or unplug the stator connector, ive tried wiring the update to the orange connectors and doesn't work at all. do you have any insight into this problem?

    also it has a new stator this spring and voltage reg. last year and have tried trid another cdi out of a pro model
  3. View Conversation
    Thanks for getting back to me so soon!!!!!
  4. View Conversation
    i have a 94 sl 750. i have two stators. i did the ohms testing and the original stator tested on the button to the ohm specs. but the guy i got it from said it didnt have spark. so i got a different stator and the exciter coil tested way off the charts. like sometimes at 5-8oo ohms. soo was the cdi box the problem? and whats one worth canadian? thanks john
  5. View Conversation
    hello just wandering if you could direct me to a good place to buy a used engine coupler and shaft for a 95 sl750 new to the ski world and lovin it just need to get it back up and going
  6. Whatcha mean?
  7. Hey Al...
  8. View Conversation
    Hey AL , I was talking with J Zigler and he said you might have a solution or idea for my prob ..... being you are considerd a polaris gooruu http://greenhulk.net/forums/showthread.php?t=84798
    thanks Darin (dr.ipper)
  9. View Conversation
    Hi ph20craft, I am new at Green Hulk, but have looked around a good bit. This is a cool site with a lot of good folks here. I am trying to solve an firing issue with my 1996 700 SLT Polaris. I wonder if you could direct me to somone who has some good used ignition parts, I would hope to find them in the newest updated version. I have found the diagnostic thread for the polaris and also a wiring schematic and the service manual on this site. Very helpful information along with you guys help. I think I made a mistake buying the whole black box off Ebay a few months ago, i'm not sure if the cdi is any good . I swaped it out and still no firing. It could be the stator causing the whole problem. With the information I have gathered here, I will troubleshoot the problem and find out where my problem is at. Thanks Robert
  10. View Conversation
    I was the computer thats bad I am going to send it off for repair,I have a old computer that I swapped in with matched injectors,however it has c-27 burnt off do you know what part of EMMS this controls??The engine starts and runs fine now.MarvinTHanks so much,it is the little yellow resistor at rear of EMMS labeled C-27 its burnt off yet that computer works fine!!Thanks Your friend>Marvin
Showing Visitor Messages 1 to 10 of 19
Page 1 of 2 12 LastLast
Page 1 of 2 12 LastLast
About ph2ocraft

Basic Information

About ph2ocraft
Love watercraft, quads and SxS's, the wife and kids are cool too.
Campbell, Ca.
Matrix, SLTX, Hurricane, SL750, Virage, GTX, GP1200R, etc.
First Name:


Matrix-two of them, because sometimes one just won't do.
MSX140 and Hurricane
Kawasaki Ultra 310
10' Yamaha FZR
17' Sea Doo RXT-X300
18' Sea Doo GTX300


Total Posts
Total Posts
Posts Per Day
Total Albums
Total Pictures
Visitor Messages
Total Messages
Most Recent Message
03-28-2017 08:35 AM
Total +1
Total +1
General Information
Join Date

52 Friends

Showing Friends 1 to 10 of 52
Page 1 of 6 123 ... LastLast