7 Visitor Messages

  1. Tap it with a rubber mallet until u hear it click. Don't forget to put a worm clamp or similar over it after.
  2. Saw a tip that you posted on how to replace a thermostat on a boat either similar or exactly like my 06 RXT. My thermo housing popped while riding last weekend. I bought the cooler thermostat to install but I'm having a very difficult time getting the nipple to seat back into the thermo housing. The tabs look like they are relatively still in tact and the O-ring is in place but the two pieces just wont seat up. They may if I really force it but haven't wanted to go that route yet. Can you give me any advice? Thanks, Mike Grogan
  3. View Conversation
    Please clear your mailbox Jeff!
  4. View Conversation
    Hey clean your mail box so I can send you a PM.
    Thanks...
  5. View Conversation
    OK thank for your time.
  6. The Rxp is a faster hull.
  7. View Conversation
    If you put a stock 215 supper charge 4 tec in that gti that you are building. Would it be any faster then a stock rxp? or it would be a waste of time unless there was Big time motor work or a turbo was done? I rode 07 gti in 3-4 chop and loved the way it cut threw it. But the stock motor was way under power. Thanks for your time.
Showing Visitor Messages 1 to 7 of 7
About JPR

Basic Information

About JPR
Location:
Down under

Statistics


Total Posts
Total Posts
963
Posts Per Day
0.22
Visitor Messages
Total Messages
7
Most Recent Message
09-15-2013 03:13 PM
Total +1
Total +1
192
General Information
Join Date
03-08-2007

3 Friends

Showing Friends 1 to 3 of 3